Drum

Rust Stains

Never leave metal items e.g. paper clips, safety pins etc. in the drum as it creates superficial rust marks in drum. If there are any rust stains remove with a non- chlorine agent. Special non-metal sponges (never use steel wool ) may also be used.

Sieves

Cleaning of Water Connection Sieves, Filter

1.Turn off Taps. Disconnect Power supply to the machine. Unscrew inlet hose from machine as well as from the tap and drain out water from the hose.

2.Pull the sieve out the magnetic valve with a pair of flat nosed pliers and clean under running water with a brush.

3.Fit Sieve back to the valve.

4.Remove the filter mesh from the tap end of the inlet hose and clean under running water with a brush.

5.Fit the filter mesh back to inlet hose.

6.Screw inlet hose back to the machine and the tap. Ensure that both the sieve and gasket are in place.

7.Turn on the tap.

Cleaning of Porthole Door Area:

terAf every wash clean vapour off porthole door. rLift the fold in the rubber gasket under porthole

periodically to remove lint and dirt preferably after every wash.

Environmental Protection/ Conservation Issues

Your washing machine uses water, energy and detergent efficiently, thereby protecting the environment and reducing your household costs.

Using your washing machine in an efficient and environmentally friendly manner:

Do not exceed recommended load.

Cottons	5.0kg
Easy-care	2.5kg
Delicates and Woollens	1.5kg

Where possible, use the 600 C Eco program instead of the 900C Cottons program. The extended washing achieves a cleaning result comparable to the 900 C program, but uses considerably less energy.

Avoid using the Prewash program [ if applicable ] when washing lightly to normally soiled laundry.

Add detergent according to the degree of soiling, amount of laundry and water hardness, and observe the dertergent manufacturer’s instructions.

Before Using Your Washing Machine For The First

Time

Caution

The washing machine must have been installed and connected properly (refer page 8)

Your appliance was tested before leaving the factory. To remove any water left over from testing procedures, the first washing cycle should be carried out without laundry in the machine.

Do not load any laundry.

1.Turn on water tap.

2.Pull out the detergent dispenser up to the end stop.

3.Pour approx. 1 litre of water into chamber II of the detergent dispenser.

4.Pour ½ measuring beaker of detergent into dispenser II. Do not use any special detergents for delicates or woollens (excessive foam).

5.Close the detergent dispenser.

6.Set the programme / Temperature selector to the maximum temperature and start the machine.

7.Turn the programme selector to Off position once program is over / Turn OFF the machine