SAFETY PRECAUTIONS
Ensurethat the machine is properly balanced on four adjustable
feet.
Ensurethat the machine is connected to 3 pin socket with good earth and 16 Amp MCB or other automatic short circuit protection devices.
qThe machine is tested with water during assembly for performance checking. Condensed droplets of water may remain inside the drum. It is advisable to run the machine without wash load in cotton 60 program with detergent for the first time after installation.
Servicing should be handled by the Company’s authorized personnel only.
rCheck label on garments for determining conditions under which fabrics are to be washed.
rUse detergent recommended for washing machine. Ensurethat the electrical line on which the machine is used can
take the required load.
rCheck the inside of drum before loading the clothes. Protectthe machine from direct sunlight and do not splash water on
it. Clean with a dame cloth.
rKeep your machine dry to avoid corrosion/rusting. Take special care to wipe the machine after cleaning the Coin trap.
rThe machine should ideally be installed on the floor. It can be installed on any suitable platform or trolley, if desired by the customer.
rClean the shell lower and detergent tray periodically by taking out the detergent tray.
rDo not pull the cord to disconnect the plug. Hold the plug itself/do not insert or remove the plug with damp hand.
rDo not drag the washing machine to its position. Always lift the or move the machine keeping the wheel’s direction in mind.
rDo not move the washing machine if it contains the wash load or when in operation.
rDo not install the machine in a damp area or bathroom, with exposure to direct shower*.
rDo not spill water over the machine*. In case of spillage, wipe dry.
36
6.Remove transit bolts.
7.Insert plastic caps provided into holes vacated and press till they click into place.
8.Keep transit bolts carefully. They will be required in case you need to shift the machine again.
9.For shifting and
10.Keep packaging material carefully. It comes handy while shifting residence.
11.PLEASE DO NOT OPERATE THE MACHINE TILL TRANSIT BOLTS HAVE BEEN REMOVED.
Setting Up
The machine should be levelled properly on the floor. However, it can be installed on any suitable platform or trolley, as desired.
Install machine in a room with adequate ventilation. Avoid a room with no windows. The back of the machine should be at least 4 inches (100 mm) away from the wall.
1.Do not place the machine on slanting, uneven, unstable surface.
2.Level the machine by using the adjustable screws provided at the bottom for levelling.
3.Loosen securing nut. Adjust the screw to change level. Tighten securing nut to ensure that screw is locked into place.
4.Make sure that the machine rests on all four feet on a level surface, at all times, to avoid vibrations during operation
5.Machine should be leveled again in case it is moved to a new site.
6.Machine is provided with ventilating openings on the base. Hence it is always recommended to put the machine on the floor after removing the carpet.
7.In countries where there are areas which may be subjected to infestation by cockroaches or other insects etc, pay attention to keep the appliance & surrounding in clean condition at at all times any damage which be caused by cockroaches etc will not be covered by the appliance guratantee.
9