John Lewis JLWM1402 1400 instruction manual How to interrupt a programme, End of programme

Page 12

12.How to interrupt a programme

Depress the “Start/Pause” button to interrupt a programme which is running, the corresponding light starts to flash. Depress the button again to restart the programme.

13.How to open the door during the cycle of a programme

You can open the door, after having set the washing machine to Pause, provided the following conditions exist:

the washing machine is not in the heating phase beyond 55°C;

the level of the water is not high;

the drum is not turning.

If these requirements are met, when you pause the washing machine, the door locked light goes off and the door can be opened.

Should it not be possible to open the door, and should it be absolutely necessary to do so, switch the machine off by turning the selector dial to “Off”.

After approximately 3 minutes, you can open the door.

Pay attention to the level and temperature of the water in the washing machine!

When you close the door to restart the programme turn the dial to the previous programme repeating the options previously selected and press START/PAUSE button.

14. End of programme

At the end of the programme, the washing machine stops automatically and displays a blinking zero.

If you had selected the “Quiet” option, the door locked light is on, the door is locked, the “Start/Pause” button light goes off, the “Rinse Hold” pilot light and the “Quiet” option light remain lit to indicate that the water must be drained.

The display shows a flashing zero. To drain or to spin see paragraph “Quiet” on page 7.

Turn the programme selector dial to Reset “Off” to switch the machine off.

Remove the laundry from the washing machine.

Check whether the drum is completely empty, by rotating it with your hand. The purpose of this is to prevent any items of laundry from remaining accidentally in the drum, where they might get damaged in a subsequent wash (e.g. by shrinking) or bleed colour into another load of laundry.

We advise you to close the water supply tap and disconnect the plug from the socket.

Leave the door ajar in order to air the washing machine.

12

Image 12
Contents JLWM1201 Spin washing machine JLWM1402 Installation Child SafetyUse Contents Materials marked with the symbol are recyclable Ecological hintsInterest Environment Machine works more economically if it is fully loadedChild safety feature Description of the ApplianceDoor locked light Detergent dispenser drawerControl Panel Programme selector dialSpin button Option buttonsDelay start button Selecting the delayed startCancelling the delayed start Start/Pause buttonProgramme phase indicator lights DisplayFollowing pieces of information are shown on the display When the programme has finished, the End light comes on Programme informationSwitch the machine on Operating SequenceLoad the laundry Measure out the detergentSelect the Delay start How to change an option or a programme during its cycleSelect the spin speed or the None option Select the desired optionsHow to interrupt a programme End of programmeLeave the door ajar in order to air the washing machine Washing Hints 1000g = 1 kgSheet Bath robeWash Care Symbols Important NotesWashing programmes Off / Reset Programme Available ConsumptionsEnergy Water Time Description SoakMaintenance and Cleaning Cleaning the water inlet filter Emergency emptying outRemove any objects from the pump impeller by rotating it Screw the pump cover fully Close the pump doorSomething Not Working Machine vibrates when SpinningDoor will not open Light has gone outInstallation Instructions Technical SpecificationsInstallation on a Suspended Floor UnpackingWater inlet Water drainageAppliance must be connected to a cold water supply Into a drainage standpipeLevelling Special conditionsInterest of the environment Onto a sink outlet spigotElectrical connection Permanent connection