When you PAUSE the cycle, and it becomes possible to open the door, provided:
•the washing machine is not in the heating phase;
•the level of the water is not high;
•the drum is not turning.
If all these requirements are met, the door locked light goes off.
Important! You must set the washing machine to Pause before you make any change in the programme in progress.
7 Display
The following pieces of information are shown on the display:
•Duration of washing programme in hours and minutes, after you have selected a programme.
2.05
While the programme is running (after you have pressed the Start/Pause button), the displayed time value decreases by one unit every minute.
•The washing machine has completed the programme: this is indicated by a flashing zero.
•The washing machine has stopped with water in the tub, at the end of the “Soak 30°” or a programme with the “Quiet” option: this is indicated by a flashing zero.
0
•Delay start, a time value indicated in hours and selected by means of the relevant button.
The delay time is displayed for 3 seconds, then the duration of the selected programme reappears. After you have pressed the Start/Pause button, the countdown begins, and the delay time value decreases by one unit every hour up to 2 hours and then by 30 minutes.
•An incorrect option selection has been made: this is indicated by the message Err when a function incompatible with the current programme is selected.
•An alarm code indicates a fault in the machine operation (see the relevant chapter).
E20
8Programme phase indicator lights
When you select a programme, the lights relevant to the phases that form the programme light up.
After you have started the programme, only the light relevant to the phase that is currently being carried out will remain lit.
8