After the draining process is completed | Fisher & Paykel WH60F60W

Care and cleaning

To clean the filter and discharge the water:

1Unplug the machine to cut off the supply power.

2To prevent water from leaking onto your floor pull the machine out from the wall, tip the machine back and place solid 100mm tall objects under both feet of the machine to ensure that the machine does not fall on to you. WARNING: Tipping the machine too far back may cause the product to slip or fall backwards, or become a hazard.

3Open the filter cover by pressing the tab on the cover downwards and pull it out towards yourself.

Fig.9 Opening the filter cover

4Draining of water using the pump outlet hose (only available on selected models)

4a Pull out the pump outlet hose from its housing.

Fig.10 Draining of water using the pump outlet hose

4b Place a large container at the end of the hose.

4c Drain the water off into the container by pulling out the plug at the end of the hose. Note: if the amount of water to be drained off is greater than the volume of the container, replace the plug, pour the water out, then resume the draining process.

After the draining process is completed:

4d Replace the plug into the end of the hose. 4e Refit the hose back into the housing.

5Remove the filter by turning counter-clockwise and wash with clean water.

6Inspect the inside of the filter housing and remove any foreign objects.

7Check the O-ring seal for cracks or breaks.

8Replace the filter by turning clockwise. Firmly tighten by hand.

9Close the filter cover by lifting it up and pressing on the tab.

10Carefully lower the machine and push it back into position.