Kenmore Washer owner manual Tools and Parts, Alternate Parts You May Need, Parts supplied

Tools and Parts

Assemble the necessary tools and supplies before beginning the washer installation. The parts supplied are in the washer basket.

Tools needed for connecting the drain hose and water inlet hoses:

•Pliers that open to 1%_in. (3.95 cm)

•Flashlight (optional)

Parts supplied:

3 4 5

1. Drain hose

2 Silver, double-wire hose clamp (for the bottom of the drain hose)

3.Yellow, single-wire hose clamp (for the top of the drain hose)

4.Water inlet hoses (2)

5.Flat water inlet hose washers (4)

Tools needed for securing the drain hose and leveling the washer:

•Open end wrench _ in. (1.43 cm)

•Level

•Wood block

•Ruler or measuring tape

Parts supplied:

12

1. Shipping strap with fastener

2 Front leveling feet with nuts (2)

Alternate Parts You May Need

Parts listed are available from your local Sears store or Sears Service Center. Please reference the service numbers

located on the back page of this manual.

3¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸•			_ _	_ _	_
If you have:	You will need to buy:
Laundry tub or Sump pump system (if
standpipe	not already		avaUable)
taller than 96
in. (2.4 m)
1 in. (2.5 cm)	2 in. (5 cm) diameter				to
diameter	1 in. (2.5 cm) diameter
standpipe	standpipe	adapter, Part
	No. 3363920
Overhead	Standard	20 gal (76 L)
sewer	39 in. (99	cm) tall drain
	tub or utility sink, sump
	pump and connectors
	(available	from local
	plumbing	suppliers)
Floor drain	Siphon break, Part
	Number 285320;			addi-
	tional drain hose,			Part
	Number 3357090			and
	connector	kit, Part
	Number 285442

Water faucets 2 longer water fill hoses:

beyond reach		6 ft (1.8 m) Part Number
of fill hoses		76314, 10 ft (3.0		m) Part
		Number 350008
Drain	hose too	Drain hose,	Part	No,
short		388423 and	hose kit,
		Part No. 285442
Drain	hose	Hose kit, Part No.
that is too long 285442
Lint clogged		Drain protector,		Part No.
drain		367031