Solutions to Common Problems
Avoid Service Checklist, continued
OCCURRENCE | POSSIBLE CAUSE | SOLUTION |
|
|
|
CODES DISPLAYED IN LED |
|
|
|
|
|
Water inlet hoses are not installed.
Install Hot and Cold water hoses and turn on Hot and Cold water supply valves.
(No or slow water fill) | Water supply valves are not turned on. | Turn on Hot and Cold water supply valves. | |
| Water supply is not adequate in installation. | Test water pressure at another faucet in the house. | |
|
| Water pressure must be at least 30 psi (260 kPa). | |
|
|
| |
| Water is being used elsewhere in the house. | Avoid running water elsewhere while washer is | |
|
| filling. | |
|
|
| |
| Water inlet hoses are kinked. | Straighten hoses. | |
| Water inlet screens are clogged. | Remove hoses and clean sediment from screens. | |
|
|
| |
| Hot and Cold inlet hoses are connected to | Connect hot water hose to hot water faucet and | |
| wrong supply faucets. | cold water hose to cold water faucet. | |
|
|
| |
(Cold water detected from Hot | Hot water heater is set too low or is a long | Measure hot water temperature at nearby faucet | |
distance from washer. | with candy or meat thermometer. Water tempera- | ||
inlet hose during Install Cycle) | |||
| ture should be at least 120°F (49°C). Adjust water | ||
|
| ||
|
| heater as necessary. |
Hot water is being used elsewhere in the house.
Avoid using hot water elsewhere before or during washer use. Your hot water system may be unable to support more than 1 use at a time.
| Drain pipe position too low and water si- | Drain pipe height must be minimum 24” above |
| phoning out drain hose. | bottom of unit. Refer to Installation Instructions for |
(water not maintaining level) |
| correct drain pipe installation requirements and |
| adjust accordingly. | |
|
| |
|
|
|
| If drain pipe height is adequate, error | Call |
| detected can only be resolved by calling | assistance. |
| service technician. |
|
|
|
|
| Drain pipe blocked. | Unclog drain pipe. |
| If drain pipe drains freely with test water | Call |
(washer experiencing drain | from a jug, error detected can only be re- | assistance. |
solved by calling service technician. |
| |
problems during cycle) |
| |
|
| |
| Error detected can only be resolved by call- | Call |
| ing service technician. | assistance. |
(Call Service) |
|
|
|
|
|
27