Operating Instructions
Other Features
Status Indicators |
| Install Cycle | |||
|
|
|
|
|
|
The estimated total cycle time will be displayed when the cycle is selected. The time may increase if water pressure is low, oversudsing occurs or the load becomes unbalanced. The estimated remaining cycle time is displayed during the cycle. The following indicators may be lighted during the cycle:
•Add a Garment
•Wash
•Rinse
•Spin
•Door Locked
•Various other codes in the LED may alert you to operating conditions that you can correct yourself before calling service. See “Avoid Service Checklist” for detail concerning these alert codes.
Reversible Door
Your washer is equipped with a reversible door. The door can be hinged on the right or left side.
NOTE
For
Run the Install Cycle before operating the washer the first time. Remove all items from the washer drum, enter Install Cycle mode and press START. For more information on performing the washer Install Cycle, refer to the Installa- tion Instructions accompanying this washer.
After running the Install Cycle, if the washer has been
correctly installed, 
(“Install Pass”) will be displayed and the washer is ready to use.
If the washer was not installed properly, 
(“No Water”), 
(“Flip Hoses” - Reverse Hot
and Cold Water Supply), or 
(“Call Service”
-
The errors may result from the following conditions:
•
- Water inlet hoses have not been attached to water supply or water supply valves have not been turned on. Install hoses correctly and turn on water supply valves.
•
- The hot inlet hose may have been connected to the cold water supply and the cold inlet hose may have been connected to the hot water supply. Check hoses for correct supply connection. If incorrect, shut off water, disconnect hoses and connect to correct inlets according to Installation Instructions.
•
- Error can only be corrected by calling a qualified technician
Repeat the Install Cycle when corrections are completed.
11