Kenmore 4900 manual Troubleshooting, Error, Noisy, vibrating, off-balance Washer level?

Page 25

II

TROUBLESHOOTING

First try the solutions suggested here to possibly avoid the cost of a service caR...

[Error!]

iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii;; ¸i:iiii!ii!ililili!iiiii i i i__i¸3iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!ii i i i i i i i i !ii!iiii!i!i!gi i i i_ii_iii i_i_i_i

[Error!]

[Error!]

_a

[Error!]

Noisy, vibrating, off-balance

H! [s the washer level?

The washer must be level. The four feet should be properly installed, and the nuts should be tightened against the washer cabinet.

All four feet of the washer must be in firm contact with the

floor. If the washer is on a pedestal, the washer must be

secured to the pedestal and all four pedestal feet must be in firm contact with the floor.

[] Washer making a different noise?

As with any new product, you will hear sounds that you are not accustomed to. You may hear various sounds when the door is locked or unlocked, and during the washing, rinsing, or spinning process. Between changes in wash actions, there will be momentary pauses. You will hear water spraying and splashing during the wash and rinse cycles. These new sounds and pauses are part of normal washer operation.

[] is washer installed on a sturdy and solid floor?

Refer to the "installation Instructions" for flooring requirements. Noise and vibration may be reduced by placing a piece of %" (19.1 mm) plywood underneath your washer.

25

(Best 2)Kmmtore 592-49003-02902A-01 EN.indd 25

2011-03-23

_,P_a_ft 9:39:59

[

Image 25

Contents Front=Loading Automatic Washer Table of Contents Protection Agreements Warranty Service Kenmore Elite Washer WarrantyPedestal Option Sears Canada Inc Toronto, Ontario, Canada IVl5B2C3Your safety and the safety of others are very important Washer SafetyIMPORTANT Safety iNSTRUCTiONS IOOiiiiS i!!!i!iiiiiiliiiiiii!!!i!i!i!iliS PedestalParts supplied Alternate PartsInstallaSon clearances Recommended installationspacing for customWasher Dimensions 1N- 51-,,4,,IRecommended Installation spacing for cabinet installation Installation, with stacked washer and dryerStandpipe drain system =wail or floor views a & B Laundry tub drain system view aFor a permanently connected washer Electrical Shock HazardINSTALLATiON iNSTRUCTiONS Clear water lines Part no. for hose extension DC97-15273AConnect the inlet hoses to the washer To keep drain water from going back into the washerPlug into a grounded 3 prong outlet Electrical Shock HazardAuto Water Level Features and BenefitsSpin Speeds Detergent Advantage System DispenserFire Hazard Washer USEModels Is notUse only HE High Efficiency detergent To fill dispenser compartments AutomaSc dispenserPausing the Child Lock function To cancel a cycleIis8!i,l,zSiiii0 ,i¸S!!!!iiiiiii@Si4il%qiiiiiii,!!!!iilili Locking conbolsHeavy Duty Wash CyclesInterior Lamp Select the LanguagePreset Cycle Set, rigs Eco Clean drumHeavy Duty Whites Perm Press WoolWhites NormalSpinOnly Soil Level selection button Guide Wash Water Temperature Suggested FabricsSteam Select Cycle Op8onSorling Preparingclothesfor washingUnloading Stain Chlorine or Color= Wash Cycle InkSave Bleach Tomato ProductsClean the following as recommended Cleaning the exteriorStoring your washer Prepare your Washer for storage as followsTo use washer again Non=use or vacation careError TroubleshootingIs washer installed on a sturdy and solid floor? Noisy, vibrating, off-balance Washer level?Wiiinot start Did you sort properly? StopsDid you overload the washer? Did you use enough HE detergent? Are you using a low speed wash cycle?Do you have hard water? Is your water colder than 60F 15.6C?Page Seairs