iNSTALLATiON iNSTRUCTiONS
IMPORTANT: Position the washer so that the rear of the unit is within approximately 3 ft (90 cm) of its final location.
Before using your Washer, you must remove the four shipping bolts from the back of the unit.
1.Loosen all the bolts with the supplied wrench.
2.Slide the bolt and spacer up and remove the bolt with the spacer through the hole in the rear wall of your washer. Repeat for each bolt.
.3. Fill the holes with the supplied plastic covers.
4.Keep the shipping bolts and spacers for future use.
Before Connect the inlet hoses to water faucets, Check to ensure a washer is inside coupling.
AB
A. Coupling
B.Washer
Connect the inlet hoses to the water faucets
Make sure the washer drum is empty.
1.Check the inlet hose to ensure a washer is inside each fill hose.
Thread the inlet hoses to the HOT and COLD faucet connections.
On the other end of the hose, check for one rubber washer per hose and install each fill hose to the water valve. Make sure the hose with the Hot printed line is attached to the HOT faucet. Tighten by hand until snug, then
ColdHot
_ Rubber washer
NOTE: For correct water use, connect both HOT and COLD water valves. If either or both are not connected, an "nF" (no fill) error can occur.
2.Turn on the "HOT" and "COLD "water supply and check all connections at the water valve and the faucet for leaks.
Cold printed | Hot printed |
NOTE: Do not overtighten or use tape or sealants on the valve. Damage to the valves can result.
9