JVC KD-G411 manual Using the standby receptions

What you can do with RDS

RDS (Radio Data System) allows FM stations to send an additional signal along with their regular programme signals.

By receiving the RDS data, this receiver can do the following:

•Programme Type (PTY) Search (see page 10)

•Standby Reception of Traffic Announcement —TA (see the following) or your favorite programme (PTY) (see pages 12 and 21)

•Tracing the same programme automatically —Network-Tracking Reception (see page 12)

•Programme Search (see page 21)

Storing your favorite programmes

You can store six favorite programme types.

Preset programme types in the number buttons (1 –6):

1Perform steps ~ and Ÿ on page 10 to select a PTY code.

2Select the preset number (1 – 6) you want to store into.

3	Repeat steps 1 and 2 to store	ENGLISH
	other PTY codes into other preset
	numbers.
4	Finish the procedure.

Using the standby receptions

TA Standby Reception

TA Standby Reception allows the receiver to switch temporarily to Traffic Announcement (TA) from any source other than AM.

The volume changes to the preset TA volume level (see page 21).

To activate TA Standby Reception

The TP indicator either lights up or flashes.

•If the TP indicator lights up, TA Standby Reception is activated.

•If the TP indicator flashes, TA Standby Reception is not yet activated. (This occurs when you are listening to an FM station without the RDS signals required for TA Standby Reception.)

To activate TA Standby Reception, tune in to another station providing these signals. The TP indicator will stop flashing and remain lit.

To deactivate the TA Standby Reception

The TP indicator goes off.

Ex.: When “ROCK M” is selected

11