Quick reference guide | Chart |
PROGRAM SELECTION BUTTON
Push “Programs” button (repeatedly) until the indicator of the required program lights up (see “Table of programs” below).
START/RESUME BUTTON
Push this button to start the selected program: the indicator lights up and goes off at the end of the program. When the door is opened during a washing cycle, the cycle is temporarily paused: the Start indicator blinks.
To resume the cycle push the Start button and close the door within 3 seconds.
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
CANCEL/OFF BUTTON
Push this button to switch off the control panel. If pressed when a program is running it cancels the program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it drains any possible liquids from dishwasher (1 minute process).
If the indicator flashes repeatedly, see page 6 - chapter ”What to do if ...”.
| Table of programs | Deter- | Consumption | ||||
|
|
|
|
|
|
| |
P | Programs |
| Loading instructions | gent | Litres | kWh | Minutes 1) |
|
| ||||||
1 | cold | Crockery to be washed later. | — | 5.0 | 0.02 | 10 | |
2 | Quickwash | 40°C | Lightly soiled crockery, with no | X | 13.0 | 0.70 | 30 |
|
|
|
|
|
|
| |
3 | Eco 2) | 50°C | Normally soiled crockery. | X | 15.0 | 1.05 | 165 |
4 | Intensive |
| Recommended program for |
|
|
|
|
70°C heavily soiled crockery, especially | X | 15.0 | 1.50 | 140 | |||
|
|
| suitable for pans and saucepans. |
|
|
|
|
5 | Half Load | 50°C | Ideal for washing a half load of | X | 13.0 | 1.00 | 130 |
|
|
| lightly or normally soiled crockery. |
|
|
|
|
1) | Program data obtained in conformity with European standard EN 50242, obtained under normal conditions |
|
|
| (without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible |
|
|
| with sensor programs as a result of the appliance’s automatic calibration system. |
|
|
2) | Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for |
|
|
| detailed information on the EN/Standard loading comparison test and other tests, contact the following address: | ADG 6500 | 5019 396 03515 |
| “nk_customer@whirlpool.com”. |
GB