Whirlpool ADG 6500 manual Select program, Wash cycle, Switching off the appliance. Everything OK

Page 5

Select program

6 Overview of programs

The max. possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance can be found on the panel (page 1).

Choose program according to the attached table of programs (page 1).

Duration of the program depends on the external conditions in the apartment, temperature and pressure etc.

Wash cycle

7 The dishwasher door must be closed and the water tap open.

To pause the program (e.g. if you want to insert an item):

-Open the door with caution (the program pauses) and insert the item/s,

(beware of HOT steam!).

-Press the START button and close the door within 3 seconds (the program resumes the cycle from where it was interrupted).

Switching off the appliance. Everything OK...

To Cancel the program on running:

-Open the door, press the CANCEL/ Off button and close the door.

-(Water drains for up to 1 minute then the appliance switches off).

To change the program in progress:

-Open the door, press the CANCEL/Off button to cancel the running program and close the door.

-(Water drains for up to 1 minute then the appliance switches off).

-Open the door and press any button except CANCEL/Off button to switch on the appliance.

-Select a new program.

-Press the START button and close the door within 3 seconds

After the program is completed appliance turns into Standby mode automatically. All indicator lamps switch off.

 

Exercise caution when opening the door: beware of hot steam.

 

8 Unload the appliance starting from the lower rack in order to avoid any residual drips of water falling onto crockery below.

 

Maintenance and care

Maintenance and care

9

Filters Check and clean if necessary

Unscrew microfilter (1), remove it (2) and remove fine sieve (3)...

Rinse under

running water...

Screw on microfilter NOTE MARK!

Insert

Rectifying minor faults yourself...

10

Spray arms Remove blockages/ deposits.

Unscrew and remove upper arm...

Unscrew and remove lower arm...

Insert and screw on upper and lower arms tightly.

Clean spray nozzles under running water (use toothpicks if necessary)...

GB -5-

Image 5
Contents Quick reference guide Filters Spray arms First time useDaily check Rinse aid indicator on the dispenser Rinse aid indicator on the control panelDaily check Daily useHow to load Upper Rack How to load the racksHow to load Lower Rack How to adjust upper rack height if availableMaintenance and care Switching off the appliance. Everything OKRectifying minor faults yourself Select programWhat to do if What to do if What to do if Precautions and general recommendationsDisconnect the mains plug We reserve the right to make technical modifications