Whirlpool GCAM2792LQ0 manual Washer Care, Troubleshooting, Cleaning Your Washer, Water Inlet Hoses

Page 8

WASHER CARE

Cleaning Your Washer

Cleaning the exterior

Use a soft, damp cloth or sponge to wipe up any spills such as detergent or bleach. Occasionally wipe the outside of your washer to keep it looking new.

Cleaning the interior

Clean your washer interior by mixing 1 cup (250 mL) of chlorine bleach and 2 cups (500 mL) of detergent. Pour this into your washer and run it through a complete cycle using hot water. Repeat this process if necessary.

NOTE: Remove any hard water deposits using only cleaners labeled as washer safe.

Water Inlet Hoses

Replace inlet hoses after five years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear or leaks are found.

When replacing your inlet hoses, mark the date of replacement on the label with a permanent marker.

Vacation, Storage, and Moving Care

Install and store your washer where it will not freeze. Because some water may stay in the hoses, freezing can damage your washer. If storing or moving your washer during freezing weather, winterize it.

Non-use or vacation care

Operate your washer only when you are at home. If you will be on vacation or not using your washer for an extended period of time, you should:

Unplug washer or disconnect power.

Turn off the water supply to the washer. This helps avoid accidental flooding (due to a water pressure surge) while you are away.

To winterize washer

1.Shut off both water faucets.

2.Disconnect and drain water inlet hoses.

3.Put 1 quart (1 L) of R.V.-type antifreeze in the basket.

4.Run washer on a drain and spin setting (see “Rinse and Spin”) for about 30 seconds to mix the antifreeze and water.

5.Unplug washer or disconnect power.

To use washer again

1.Flush water pipes and hoses.

2.Reconnect water inlet hoses.

3.Turn on both water faucets.

4.Plug in washer or reconnect power.

5.Run the washer through a complete cycle with 1 cup (250 mL) of detergent to clean out antifreeze.

TROUBLESHOOTING

First try the solutions suggested here and possibly avoid

the cost of a service call...

Washer won’t fill, rinse or agitate

Check the following:

Is the power cord plugged into a grounded 3 prong outlet?

Is the indicator on the Cycle Control knob properly lined up with a cycle? Turn the Cycle Control knob to the right slightly and pull to start.

Are the water inlet valve screens clogged?

Are both the hot and cold water faucets turned on? Is the water inlet hose kinked?

Does the water level seem too low, or does the washer appear to not fill completely?

The top of the agitator is much higher than the highest water level. This creates a perception that the washer is not filling completely. This is normal.

Washer stops

Check the following:

Is the power cord plugged into a grounded 3 prong outlet?

Is the indicator on the Cycle Control knob properly lined up with a cycle? Turn the Cycle Control knob to the right slightly and pull to start.

Are the water inlet valve screens clogged?

Are both the hot and cold water faucets turned on? Is the water inlet hose kinked?

Is there power at the plug?

Check your electrical source or call an electrician.

Has a fuse blown or is the circuit breaker open? If problem continues, call an electrician.

Are you using an extension cord? Do not use an extension cord.

Is the washer in a normal pause in the Permanent Press cycle?

The washer pauses for about 2 minutes in the Permanent Press cycle. Allow the cycle to continue.

The Gentle cycle features periods of agitation and soak.

Is the lid open?

The lid must be closed during operation.

Is the washer overloaded? Wash smaller loads.

8

Image 8
Contents Commercial Washers Lavadoras ComercialesUse & Care Guide Manual de Uso y CuidadoTable of Contents ÍndiceWasher Safety Your safety and the safety of others are very importantParts and Features Washer USE Understanding Washer CyclesLoading Normal SoundsStarting Your Washer Water Temp Use For HotWarm ColdSelecting a Cycle Rinse and SpinDrain and Spin Adding Liquid Chlorine BleachTroubleshooting Cleaning Your WasherWasher Care Water Inlet HosesIs there excessive sudsing? Is your voltage low?Washer leaks Check the following Is the sink or drain clogged?For further assistance If you need replacement partsGearcase assembly covered by your warranty Whirlpool Commercial Washer Warranty Whirlpool Corporation will not pay forPage Seguridad DE LA Lavadora Su seguridad y la seguridad de los demás es muy importantePartes Y Características Panel de controlSonidos normales Para comprender los ciclos de lavadoCómo cargar Puesta en marcha de su lavadora Temperatura del Para uso con Agua HOT CalienteWarm Tibia Cold FríaDesaguar y exprimir Cómo seleccionar un cicloEnjuagar y exprimir Cuidado DE LA Lavadora Cómo agregar el blanqueador líquido Con cloroLimpieza de su lavadora Mangueras de entrada del aguaLa lavadora se detiene La lavadora no desagua ni exprimeLa lavadora hace ruidos La lavadora pierde aguaLa canasta de la lavadora está torcida Funcionamiento del agitadorCarga demasiado mojada Residuos o pelusa en la cargaPrendas deterioradas Si necesita piezas de repuestoPara obtener más asistencia Su garantía cubre el mecanismo de engranajesGarantía DE LA Lavadora Comercial Whirlpool Whirlpool Corporation no pagará porNotas 8524800