Control Panel, Beforeusingthewashingmachine

WATER SELECTOR

Soft Normal

WASH SELECTOR

Wash Spin

BEFOREUSINGTHEWASHINGMACHINE

•Remove the cap-hose

from the drain hose.

•In the case of pump drained

washer, remove the cap-hose from the drain hole.

PRECAUTIONS WHEN OPERATING

•Don't use excessively hot water. (50˚C or more)

Plastic parts may be deformed or damaged. Also, clothing may be deformed or decolored.

•Before washing,check all pockets.

If nails or pins remain in pockets,they may damage the washer or clothes.

•Close the water tap a little if the water pressure is too high.

•Never splash water on the control panel.

•Be sure to cover with the inner cover on laundry before spinning. This prevents laundry from

being tossed out and damaged.

•To avoid water splashes, close the wash tub lid.

•Be sure laythe drain hose down.

(in case no drain pump)

CAUTIONS

•Be sure that the washer is grounded.

To avoid electrical shock,use a metal pipe for the ground connection. But, don't ground the washer with gas pipes or telephone lines to avoid to dangers of explosion or lightning strike.

•Do not put your hands into the spin dryer basket when it is

spinning.

Your fingers can be caught by spinning laundry and damaged.

•Never allow children to operate

or play with the washer.

Children playing with the washer may accidentally fall into the washing tub.

•Disconnect the power cord from the power supply when not in use.

•Ventilation opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.

•If the supply cord of this appliance is damaged, it must only be replaced by a repair shopappointed by the manufacturer, because special purpose tools are required.

•Warning to avoid overfilling and damages this appliance must be filled with the operator present using a moderate water supply pressure only.

•Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

•To avoid overfilling and damages this appliance must be filled with the operator present using a moderate water supply pressure only.

CONTROL PANEL

1. WASH TIMMER		0
This is used to set the	15
			3


wash time, 1-15 minutes. 12		6
		9
		WASH TIMER

2.CYCLE SELECTOR

This is used to set the	Wash/Rinse			Wash
This is used to set the
Washing/Rinsing		Drain Rinse			Drain
or Draining.
	CYCLE SELECTOR		CYCLE SELECTOR
3. SPIN DRY TIMER	0
	5	1

This is used to set the
This is used to set the
spin time, 1-5 minutes.	4	2

SPIN DRY TIMER

4.WATER SELECTOR(FOR SW-50B1)

During washing, WATER SELECTOR KNOB should be selected.

During spin rinsing, WATER SELECTOR KNOB should

be selected.

5.WASH SELECTOR

This is used to select wash action. You can wash laundry effectively by various methods.