ADDITIONAL RINSE
1After rinsing you can select this course for more effective rinse
(Don't just select this course for rinse.) Load the laundry evenly into the spin basket.
2 Set the WATER SELECTOR KNOB to SPIN and
Wash Spin
CYCLE SELECTOR
KNOB to ‘DRAIN’.
3 Supply water for about 1 minute. 
Adjust the water flow to prevent overflow from the wash tub.
4 After completing the water supply, cover the laundry with
safety cover and close the inner lid.
5 Close the spin dryer lid.
6 Set the SPIN DRY | 5 | 1 |
TIMER 2~3 minutes.
4
INSTALLATION
LOCATION
Leave some space of
at least 15cm between the washing machine and the wall.
Place the washing machine on a sturdy flat surface.
If the washer is placed on an uneven or weak surface, noise or vibration may be occured. (Allowable is 2˚)
Never install the washing machine near water. Do not place the washing machine in steamy rooms or where the washing machine is directly exposed to rain. Moisture may damage electrical insulation and cause an electrical shock to occur.
Avoid direct sunlight or heating devices.
As plastic and electrical components are affected by direct heat, never place the washing machine near heaters, boilers, etc., or under direct sunlight.
Install the drain hose | 70~80cm |
about 70~80cm above |
the ground for pump model.
MOUNTING THE LEGS
Lay down the washer with its back facing downward. Insert four legs into the leg mounting
sections of the base corners of the main body.
Insert the claw of the | Claw |
leg with the square | Square |
hole of the leg | hole |
2 | |
mounting section, | 1 |
and push the leg in |
|
the arrow direction |
|
as shown in the Leg figure until it clicks.
CHANGING THE POSITION 
OF THE DRAIN HOSE
Before attempting to change the position of the drain hose, disconnect the plug from the outlet.
1.Route the drain hose inside the machine. 2.Take out the drain hose from the opposite hole
and insert the drain hose into the hose holder.
2 
1
Hose holder
CONNECTING THE DRAIN HOSE 
After attaching the connector ring(a), insert the drain hose(b) in the draining direction.
a 
b
CONNECTING THE DRAIN HOSE 
1. Before connecting the drain hose, remove the cover (a) from the drain hole.
2.After pressing the joint ring (b), insert the drain hose(c) to drain direction.
(a)
(C) 
(C)
(b)(b)
(In case of pump drained washer)
4