Assembling the RAT Protection Panel

1. It is easier engaging the shutter when

2. Insert the shutter completely through the

the set is lifted up a little, as shown in the

engagement hole from the back.

ﬁgure below.

HOW TO PUT THE DETERGENT IN

1.Open the detergent box by pulling in the direction of the arrow as shown in the

ﬁgure and then put the powder detergent in the detergent box.

2. Put in one-time amount of detergent evenly so the detergent may not brim over the box.

Slide and open the cover in the direction of the arrow, insert the rinse detergent, and slide and close it in the reverse direction.

•When a proper amount (one time does) of fabric softener is stored in the softener inlet,it is automatically put in at the last rinsing cycle.

• Do not use detergent, bleach or starch into the Softener Inlet.

•Using too much softener may produce unsatisfactory results.

•Do not open the lid during the Spin Dry cycle. If added too early, its effectiveness will decrease.

•Do not leave the softener into the Softener Dispenser for a long time. Because softner became stiff.

1. Pull out the ﬁlter and wash well.

2.Pull in the ﬁlter and connect the hose to the inlet water

valve tightly.

3.Check if there is a leakage.

Note to tighten up the connector.

installation & maintenance _19