Whirlpool 3358974 Tbols needed fm Parts supplied for itaanatia, Recommended

Untape and open washer lid. Remove packages and hoses from washer.

Check location where washer

will be installed. Proper c

installation is your responsibility. _.

Make sure you have everytt ling necessary for correct

installation.

I;

Earthed electrical outlet is ’ required. See Electrical requirements.

Standpipe	drain system:		Needs
a two-inch (5.1 centimeters)
minimum diameter stand-pipe
with minimum carry-away
capacity	of	17
gallons (64 liters)
per minute.		Top
of standpipe
mustbeatleast		a
34 inches	(86
centimeters)		-
high and	no
higher than				I
52 inches	(132
centimeters)
from bottom		of	Important:	Observe all governing
washer.			codes and	ordinances.
Floor drain	/
system requires

Hot and cold water faucets: Must be within 4 feet (122 centimeters) of the back of the washer and provide water pressure 5 100 PSI04.5-689.6

laundry tub drain system: Needs a 20-gallon (76 liter) laundry tub. Top of tub must be at least 34 inches (86 igh and no higher than

centimeters) from

If a longer drain hose is needed, drain hose (Part No. 388423) and hose extension kit (Part No. 285442) are available from K.I.C. Ltd. If drain hose must be shortened, use kit (Part

No. 285442).

I

a siphon break, Part No.

A \\

I

floor: r entire

Support: Floor must be sturdv enouah to suooort w&her weight of 3 15 pounds ( 143 cogram’sj.

		Product		Damage
		Do Not store or operate
Maximum	slope	washer	below	32OF(0°C)
		(some	water	may remain in
washer,	1 inch	washer).
		See Use 81Care Guide for
		“Winterizing”		Information.

Failure to follow above may

result in product damage.

I

Tbols needed fm

Parts supplied for itaanatia

Remove parts from packages. Check that all parts were included,

literature	package	1 drain	hose
(Not supplied with		2 inlet	hoses
all models.)		6 flat water hose
1 hose clamp		washers
1 small clamp		2 front-leveling legs
2 faucet	adaptors	with	nuts

Elect&al reqttirwnats

Electrical Shock Hazard

l Electrical earth is required on this appliance.

l If cold water pipe is interrupted by plastic, non-metallic gaskets or other insulating materials, Do Not use for earthing.

lDo Not earth to a gas pipe.

l Do Not modify the power supply cord plug. lf it does not fii the outlet, have a proper outlet installed by a qualified electrician.

lDo Not have a fuse in the neutral or earthing circuit. A fuse in the neutral or earthing circuit could result in an

electrical shock.

l Do Not use an extension cord with this appliance.

l Check with a qualified electrician if you are in doubt as to whether the appliance is properly earthed.

Failure to follow these instructions could result in serious injury or death.

If codes permit and a separate earthing wire is used, it is recommended that a qualified electrician determine that the earthing path is adequate.

220/230-votts, 5.0 amps.

50 Hz.

Electrical earth is required on this appliance.

A fused electrical supply is required. (Time-delay fuse or circuit breaker is recommended.) It is recommended that a separate circuit serving only this appliance be provided.

Recommended

earthing method

For your personal safety, this appliance must be earthed. This appliance is equipped with a power supply cord having an earthed plug.

To minimize possible shock hazard, the cord must be plugged into a mating earthing-type wall receptacle, earthed in accordance with local codes and ordinances. See Figure 1. If a mating wall receptacle is not available, it isthe personal responsibility and obligcrtion of the customer to have a properly earthed wall receptacle installed by a qualified electrician.

Figure 1

Panel A