Whirlpool 3358974 Now start, With washer in laundry area Completely out bf the & wagher

Now start...

With washer in laundry area.

completely out bf the & wagher.

1. @--&

Read, then remove label that covers drain connector. Pull to completely remove the shipping strap with 2 cotter pins from the inside of the washer.

Pull firmly to remove the other I’’

end of shipping strap from the back of the washer. The shipping strap plug must be completely removed from the washer for the self-leveling legs to be released.

Save the shipping strap for use in Step 16.

Use new hoses and washers that came with your Whirlpool washer.

coupling washer

Insert a flat washer into each end of the inlet hoses. Check that washers are firmly seated in couplings.

3 I Attach hose (without adaptor) to bottom inlet valve opening first; then second hose (without adaptor) to top inlet. Tighten couplings by hand. Then use pliers to make an additional two-thirds turn.

IMPORTANT:THISPROCEDUREMUSTBE FOLLOWEDTO ASSUREPROPER INSTALLATION.

4 To prevent the drain hose from n coming off or leaking, it must be

installed per the following instructions:

1. Wet the inside end of the drain hose with tap water. DO NOT USEANY OTHERLUBRICANT.

Numbers correspond to steps.

2.Squeeze ears of clamp with pliers to open and place clamp over the end of the drain hose.

3.While holding clamp open, work end of drain hose onto drain connector until drain hose is within l/4 inch (0.64 centimeters) of ribbed stop.

4.Position clamp over the drain hose area marked “clamp.” Release clamp. Clamp should be l/4 inch itO.,centimeters) from end of drain

5 Open

n clamp and slide over “hook” end of drain hose to secure the rigid and corrugated

sections together. +

Floor Damage

Slide washer onto cardboard or hardboard before moving across floor.

Failure to do so may cause damage to floor covering.

6 Move washer close to final

n position. Put “hook” end of drain hose into laundry tub or standpipe. Check for proper length of drain hose.

7n DO NOT FORCE EXCESSLENGTHOF DRAIN HOSE DOWN THESTANDPIPE. THIS COULD CAUSE SIPHONING.

Before attaching	water	inlet
8 n hose, run water through both
faucets into a bucket.	This will	get rid of

particles in the water lines that might clog hoses. Mark which is the hot water faucet.

coupling washer adaptor

9 Attach bottom hose with

n adaptor (inlet marked ‘H’) to hot water faucet. Attach top hose with adaptor (inlet marked “C’) to cold water faucet. Tighten couplings to faucet by hand; then use pliers to make final two-thirds turn.

Panel B