Bolt

14.If washer is not level, adjust the front legs up or down. Make final check with level.

When washer is level, use wrench to turn nuts on front legs up tightly against washer base. If nuts are not tight against washer base, the washer may vibrate.

15.On coin-operated washers, remove the service door of the meter case. Lift the service door up at the back and remove. Carefully insert coin slide with the coin slide extension attached into front opening and secure with the 4.8 mm (3/16") mounting bolt from inside the meter case. The coin slide may need to be partially pushed in to insert mechanism in the front opening. Replace meter case top and service door. Insert coin vault with lock and key.

notches

conversion bar

16.Put the coin vault with lock and key in the meter case opening. A larger-capacity coin vault can be

17.CHECK ELECTRICAL REQUIREMENTS. BE SURE YOU HAVE CORRECT ELECTRICAL SUPPLY AND RECOMMENDED GROUNDING METHOD.

18.

Check that all parts are now installed. See parts list, Page 3. If there is an extra part, go back through steps to see which step was skipped.

19.Turn on water faucets and check for leaks. Tighten couplings if there is leaking. Do Not overtighten; this could cause damage to faucets.

20.Check that you have all of your tools. Check that the shipping strap with 2 cotterpins and plug was removed from the back of the washer and used to secure the drain hose.

If entire strap is not removed, washer may vibrate and be noisy.

22.Check the wash cycle time. The coin-operated washer has a

9-minute wash in the Normal cycle. Remove the meter case top of coin- operated washers to manually start the timer. Start the washer and allow it to complete the Normal cycle.

Rotate counter-	timer “off” position
clockwise only.

timer-front view

Coin-operated timers can be started by turning the clutch assembly counterclockwise until the washer starts to fill with water.

23.If the washer fails to start or does not give the proper washer cycle time, the clutch assembly of the coin-operated timer can be adjusted. Remove the timer from the meter case. Adjust the clutch assembly screw clockwise if the washer does not start after the coin slide mechanism has been fully actuated in or out. Adjust the clutch assembly screw counterclockwise if the washer segment of the Normal cycle was less than 9 minutes.

installed. Use a knife to carefully remove the paint along the seam at the bottom of the conversion bar. Use a blade screwdriver and a hammer to lightly tap along the seam area. Raise the conversion bar up to the notches in the sides of the vault opening. Remove the conversion bar and drawer guide. Install new guide (found in parts bag) and the larger coin vault.

PAGE 5

timer clutch

21.adjustment screw Untape power supply cord

and plug into grounded outlet.