Electrolux FWD 1210 manual Unpacking, Positioning, Installation on a Suspended Floor

Page 25

Unpacking

All transit bolts and packing must be removed before using the appliance.

You are advised to keep all the packaging for re-use in case the machine is to be transported again.

Using a spanner unscrew and remove the rear right bolt.

Set the machine upright and remove the two remaining bolts from the back.

Pull out the three plastic spacers from the holes into which the bolts were fitted.

Plug the open holes with the plugs which you can find in the envelope containing the instruction booklet.

Lay the machine gently on its back, making sure that the hoses are not squashed.

P0256

P0020

Remove the polystyrene base and take off the bottom panel by unscrewing the central screw. Carefully slide out the right polythene bag.

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units.

P0457

P0015

Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.

Your new washing machine has been designed to be permanently plumbed in to your home’s water supply and drainage system. However, if this is not possible, it may be connected to suitable existing taps with the drain hose discharging into a sink.

Repeat the operation for the left and central polythene bags.

Re-fit the bottom panel using the 4 screws supplied with the door hinges (in the plastic bag) and the previously removed screw.

The appliance has one inlet hose, with female 3/4” BSP thread connectors.

If this connection is not compatible with the plumbing of the existing installation, a variety of connectors are available from good hardware stores and plumbers merchants to suit most domestic plumbing. Any

P0016

P0453

alteration to your existing plumbing must be carried out by a competent person, or qualified plumber.

Installation on a Suspended Floor

Suspended wooden floors are particularly susceptible to vibration. To help prevent vibration we recommend you place a waterproof wood panel, at least 15 mm thick under the appliance, secured to at least 2 floor beams with screws. If possible install the appliance in one of the corners of the room, where the floor is more stable.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents WASHER-DRYER Child Safety InstallationUse Contents Ecological hints Your New Washer-DryerInterest Environment Description of the Appliance Child safety featureDetergent dispenser drawer Drying time selector dial Drying indicator lightQuick Wash button Half Load buttonMains-on light ON/OFF button10Programme selector dial Operating Sequence At the end of the programme Start the machineTo drain the water and spin, release the same button again Washing 2 KG of Mixed Fabrics AT 50C Measure out the detergent and the fabric softenerSelect the required time Select the programmeDrying 2.5 KG of Cotton Autodrying 1.5 KG of Mixed Fabrics Select the required option1000g = 1 kg Washing and Drying HintsDrain pipe, even during the drying cycle Which form? Which detergent?Washing Programmes Synthetic Store dry Drying ProgrammesIron dry Important Notes Wash Care SymbolsMaintenance and Cleaning Water inlet filter Emergency emptying outSomething Not Working 0870 5 Service & Spare PartsStandard guarantee conditions Guarantee ConditionsEuropean guarantee Customer CareTechnical Specifications Installation InstructionsWashing DryingUnpacking Installation on a Suspended FloorPositioning Water drainage Water inletAppliance must be connected to a cold water supply Into a drainage standpipeInterest of the environment Special conditionsLevelling Onto a sink outlet spigotPermanent connection Electrical connectionDoor Building-inHinges Mounting the doorDrill four fixing holes see Fig. G
Top Page Image Contents