Electrolux EWW 1292 Delay Start button, Start/Pause button, Programme phase indicator lights

Page 13

An alarm code indicates a fault in the machine operation (see the relevant chapter, "Something Not Working")

9 “Delay Start” button

This button makes it possible to delay the starting of the programme 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 23 hours.

The delay you have selected is shown on the display for about 3 seconds; afterwards, the duration of the programme reappears.

You must select this option after you have set the programme and before you press the “Start/Pause” button.

The time value shown on the display will decrease by one unit every hour.

You can change the delay time at any moment, before you press the “Start/Pause” button.

If you have already pressed the “Start/Pause” button, and you wish to cancel the delay time, proceed as follows:

set the machine to PAUSE by pressing the “Start/Pause” button;

press the “Delay Start” button until the symbol 0 is displayed.

press the “Start/Pause” button again.

10 “Start/Pause” button

This button has two functions:

Start: after you have selected the desired programme and options, press this button to start the machine. The light above the button will stop flashing and remain lit.

If you have selected a delay time by means of button 9, the countdown will begin and will be shown on the display.

Pause: when you press this button again, the programme in progressis interrupted. The light above the button will start flashing. To restart the programme, press the button again.

Start/

Pause

When you PAUSE the cycle, and it becomes possible to open the door, provided

the machine is not in the heating or drying phase;

the level of the water is not high;

the drum is not turning.

Important!

You must set the machine to PAUSE before you make any change in the programme in progress.

11Programme phase indicator lights

When you select a programme, the lights relevant to the phases that form the programme light up.

ENGLISH

Important!

The “Delay Start” cannot be used with “Drain”, “Spin” or “Gentle Spin” programmes.

Prewash/Wash

Rinses

Spinning

Drain

Drying

After you have started the programme, only the light relevant to the phase that is currently being carried out will remain lit.

13

Image 13
Contents Instruction Booklet Dear customer Contents General safety Disposal Child safetyTips for environmental protection Packaging materialsWashing Drying Technical specificationsUnpacking InstallationWater inlet Electrical connection Water drainageDescription of the appliance Your new washer-dryerDetergent dispenser drawer Control panel UseTemp. button Spin speed buttonPrewash button Option buttonsExtra Rinse button Auto Dry buttonExample Selection of drying time in minutesProgramme phase indicator lights Delay Start buttonStart/Pause button Programme informations Washing hints Quantity of detergent to be used Detergents and additivesDo not use acetone on artificial silk Drying hints Operating sequence Select the Delay Start Select the temperatureSelect the spin speed or Rinse Hold option Select the desired optionsAt the end of the programme How to change an option or a programme during its cycleDrying 3,5 KG of Cotton Washing programmes Programme tableExtra rinse Spin reductionDegree Type of fabric Max. load Spin speed Drying time Mins Timed dryingEnergetic wash Delicate wash Dry cleaningBleaching IroningDoor seal MaintenanceBodywork Drain pumpWater inlet filter Frost precautionsEmergency emptying out Something not working? Problem Possible causeLaundry is not spun enough Spinning starts late orMachine will not dry or Laundry is not dry enoughElectrolux Group. The world’s No choice