Problem | Possible cause | |
• Spinning starts late or the | • The electronic unbalance detection device has cut | |
laundry is not spun enough: | in because the laundry is not evenly distributed in | |
the drum. The laundry is redistributed by reverse | ||
| rotation of the drum. This may happen several | |
| times before the unbalance disappears and normal | |
| spinning can resume. If, after few minutes, the | |
| laundry is still not evenly distributed in the drum, | |
| the machine will spin at a lower speed. If at the | |
| end of the programme the laundry is not spun | |
| enough, redistribute the load manually and select | |
| the spin programme. | |
|
| |
• The machine will not dry or the | • The water tap is closed (E10). | |
laundry is not dry enough | • The drain filter is clogged (E20). | |
• The drying time or degree of dryness has not been | ||
| ||
| selected. | |
| • An appropriate drying time or degree of dryness | |
| has not been chosen. | |
| • There is too much laundry inside the appliance. | |
|
| |
Water is not | The machine makes an unusual | |
visible in the machine. The machine, | ||
which is the result of modern technology, runs | noise. The machine is fitted with a commutator | |
in a very economical way with low water | motor which improves machine | |
consumption. Performance is | performance. | |
nevertheless excellent. |
|
ENGLISH
P1035UK |
If you are unable to identify or solve the problem, contact our service centre. Before telephoning, make a note of the model, serial number and purchase date of your machine: the Service Centre will require this information.
P1034UK
| Mod |
| Prod. No |
P0042 BD | Ser. No |
|
29