22electrolux
Cleaning the water inlet filter
If you notice that the machine is taking longer to fill, check that the filter in the water inlet hose is not blocked.
1.Turn off the water tap.
2.Unscrew the hose from the tap.
3.Clean the filter in the hose with a stiff brush.
4.Screw the hose back onto the tap.
Emergency emptying out
If the water is not discharged, proceed as follows to empty out the machine:
1.pull out the plug from the power socket;
2.close the water tap;
3.if necessary, wait until the water has cooled down;
4.open the pump door;
5.place a bowl on the floor and place the end of the emergency emptying hose into the bowl. Remove its cap. The water should drain by gravity into the bowl. When the bowl is full, put the cap back on the hose. Empty the bowl. Repeat the procedure until water stops flowing out;
6.clean the pump if necessary as previously described;
7.replace the emergency emptying hose in its seat after having plugged it;
8.screw the pump again and close the door.
Frost precautions
If the machine is installed in a place where the temperature could drop below 0°C, proceed as follows:
1.Turn off the water tap.
2.Unscrew the inlet hose.
3.Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out.
4.Screw the water inlet hose back on and reposition the emergency emptying hose after having put the cap on again.
5.When you intend to start the machine up again, make sure that the room temper- ature is above 0°C.
What to do if…
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the red pilot light of button 8 blinks, one of the following alarm codes appears on the display and some acoustic signals sound ev- ery 20 seconds to indicate that the machine is not working:
•
: problem with the water supply.
•
: problem with the water draining.
•
: door open.
Once the problem has been eliminated, press the button 8 to restart the programme. If after all checks, the problem persists, con- tact your local Service Centre.