Making the right choice is important. And it’s easy.
Here I’m in control
Knob A : Wash
Programs
Washer knob and programmed start
Use this knob to select the wash program.
Turn this knob clockwise only. To select a program, you should turn the knob so that the word/ number of the desired program is in line with the pointer on the knob.
Now press on/off button I (position I), pilot lamp L will start flashing. After 5 seconds, the setting will be accepted, pilot lamp L will stop flashing (staying lit) and the wash cycle will begin.
If you want to interrupt the program in progress or set a new one, select one of the OFF positions and wait 5 seconds. When the cancellation has been accepted, pilot lamp L flashes, and you can then turn the appliance off.
You can use this knob to delay the appliance's operation.
Select one of the 4 delay time positions, press the on/off button I in and wait 5 min. The setting has now been accepted (pilot lamp L stays lit) and you can select the program you desire. Pilot lamp L has a particular flashing motion (2" on and 4" off) to indicate that a delayed start has been set.
During this phase, you can open the appliance door and change the washing load, should you wish to do so.
After the wash cycle has been set and accepted by the washer- dryer, turning the knob will have no effect (except for when it is on position OFF (Stop).
Drying cycle knob
This control allows you to preset the drying time you want according to your requirements which may be “damp dry” ready for ironing, or “bone dry” ready for putting away. For more details see the drying time table on page 9. After all the controls have been correctly set, the dryer will start to operate as soon as you close the door.
Temperature control knob
It is used to set the wash tempe- rature in the recommended program table on pg. 11. It also allows you to reduce the tem- perature recommended for the selected program, and even to set a cold wash cycle.
Detergent dispenser
It is divided into 3+1 sections:
1.Detergent for
2.Detergent for the main cycle wash;
3.Fabric conditioner;
4.Bleach.
The detergent dispenser is here (for details see page 12).
Prewash
With this button, you can pre- wash on all programs except the Wool program. (see page 11).
Easy iron
This function allows your clothes to come out of the machine without wrinkling, making it much easier to iron. You can use it with Permanent Press and Delicates programs.
Press this button in such programs and the wash cycle will come to a stop on one position Easy iron.You can complete the cycle by pressing button F again.
Note: If you run a dry cycle, pressing this button the machine will not carry out the easy iron function.
1200 RPM Throttle Down Use this button to reduce the spinning speed from 1200 to 600 rpm for the cotton and linen programs and from 850 to 450 rpm for the Permanent Press fabrics programs.
Extra Rinse
This function adds one rinse cycle for Cotton and
Permanent Press fabrics. Use of this function is recommended for improving rinsing results when washing
full loads and large quantities of detergent are used.
Recommended in case of detergent contact allergies.
To turn on the
Turning the appliance off does not cancel the selected program.
Drying cycle lamp
When this lamp is on, it means that knob B has been set on a drying cycle and at the end of the wash cycle, the appliance will run the selected tumble drying cycle.
Instructions for installation and use 10