Installation
When the new washer-dryer arrives
Whether new or just transported to a new house, installation is extremely important for the correct functioning of your
After removing the appliance from its packaging, check that it is intact. If in doubt, contact Equator immediately. The inside of the machine is supported, for transportation, by four shipping bolts on the back panel.
Before using the
Attach the two rubber hoses provided to the red (hot) and white (cold) water inlets on the back (top right) or the appliance. Connect the other ends to the appropriate
Leveling
The
WARNING !
Excessive Weight Hazard
Use two or more people to move and install your appliance. Failure to do so can result in back or other injury
The front feet are
WARNING 
Electrical Requirements
Electrical Shock Hazard (death, fire or electrical shock):
1)Plug into a grounded 3 prong outlet.
2)Do not remove ground prong.
3)Do not use an adapter or an extension cord.
Retain the shipping bolts, spacers and washers. Should you move residence then these should be replaced to support the inside of the machine to prevent damage when transporting the machine.
For your own protection, and to prevent accidents, injury and fire, please read the following carefully:
1.Destroy the carton and plastic bags, after the
2.Children should never be left alone or unattended in the area where appliances are located.
3.Washer installation and grounding must be done in accordance with local codes by a qualified installer. Installation instructions are packed in new washer to the installer’s reference.
4.ONLY the Equator Low Sudsing detergent is recommended for this appliance. To order your box of Equator detergent call
5.The washer must be plugged into a properly grounded 3- prong electrical outlet. For your safety, the third or round grounding prong must never be removed.
DO NOT USE AN EXTENSION CORD.
6.Repair or replacement of a part should be made only by a qualified service technician to prevent personal injury or damage to the machine. For a list of authorized repair service agents, call Equator Service at
7.Disconnect power to the washer at the circuit breaker or fuse box, or unplug the machine in an emergency when servicing is required. Have the installer show you and label the proper switch or fuse at the electrical disconnect box.
WARNING - The Appliance should be connected to an Individual Branch Circuit with N.. 14 AWG Wire and Protected by 15 A Fuse.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of malfunction, or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current. This appliance is equipped with a cord having an equipment- grounding conductor and grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
WARNING - Improper connection of the
Do not modify the plug provided with the appliance. If it will not fit the outlet, have a proper outlet installed by a qualified electrician.
Warning !
The company denies all liability if and when these
instructions are not respected. Plastic bags, expanded styrofoam, nails and other packaging parts are not children’s toys, are potentially dangerous and should be disposed off properly.
Instructions for installation and use 6