Hotpoint BWM12 instruction manual Vi. Fitting your appliance into your Kitchen

Page 9

vi. Fitting your appliance into your

kitchen...

Inserting the machine into the cabinet:-

-Push the machine into the opening, aligning it with the cabinets (Fig.8).

-Regulate the adjustable feet to raise the machine to the appropriate height.

-To adjust the position of the wooden panel in both the vertical and horizontal directions, use the C and D screws, as shown in Fig.9.

Important: Close the lower part of the appliance front by ensuring that the plinth rests against the

floor.

Fig. 8

Fig. 9

Move the appliance into position, care must be taken that the Water Supply pipes and the Drainage hose are not kinked or trapped.

Direct the mains cable towards the electrical socket to be used but DO NOT plug in at this stage.

There must be at least 2mm clearance at the sides and top of the appliance. The back of the appliance must also remain some distance away from the back wall. If the recessing cavity is higher than 820mm, the opening between the floor and sides of the appliance (when installed at the end of a line of furniture) must be completely closed in.

Remember you may be charged for a service call if a problem with your appliance is caused by incorrect installation or misuse.

9

Image 9
Contents Instructions for Installation and Use Important Information Electricity SupplyInstallation Instructions ContentsRemove Transit Screws If the fill hoses are too short If the Grey drainage hose is too short StandpipeFitting the Door Panel Door Mounting AccessoriesFitting the Door Panel and Plinth Inserting the machine into the cabinet Adjusting the appliance height Accessories provided for height adjustmentControls ControlsUnderstanding the Control Panel Washing Machine Washer DryerGetting to Know Your Appliance Functions Washer Dryer Washing Machine Choosing a ProgrammeBWD12 Washer DryerAdding Detergent Dispenser DrawerSetting a Wash Programme / Starting the appliance Using your applianceCancelling or changing the programme Delayed startCombined Washing and drying programme Drying onlyWe recommend a 60 minute drying cycle for a 1kg load Washcare tips WashingItems Not Suitable For Tumble Drying Removing and Cleaning the Dispenser Drawer CleaningCleaning the Exterior Cleaning the DoorGeneral Maintenance TroubleshootingAfter Sales Service Guarantee Key Contacts