iv. Connect to a Drainage System...
●Connect up the drain hose, after fitting the hooked end support supplied in the machine.
●Ensure the drainage hose is not obstructed, trapped or kinked.
●Any extension of the drainage pipe must be no longer than 1 metre, it must have the same inner diameter and must have no constrictions of any nature.
●Do not position standpipe near an electrical outlet.
We recommend one of the following drainage methods:-
Standpipe
Note: Ensure the standpipe has a minimum diameter of 38mm.
●The standpipe should be installed away from the rear of the appliance.
1.Ensure hooked end of drain hose is positioned between 100 and 60cm above the bottom of the machine.
2.Untie the end of the GREY drainage hose from the rear of the appliance and place approximately 100mm into the standpipe or sink trap spigot.
●Ensure the drain hose is firmly in position, to prevent it coming away while the machine is in use and causing a flood.
Sink Waste System
Note: Ensure the sink outlet pipe has a minimum diameter of 32 mm.
1.Untie the end of the GREY drainage hose from the rear of the appliance.
2.Reposition ‘hooked end’ support as required along the GREY drainage hose.
3.If fitting an under sink waste disposal unit cut out the membrane, bung or blanking plug.
4.Attach the GREY drainage hose to the under sink waste
disposal unit securely, using a suitable hose clip. | cut off end |
5.Raise the hose to a minimum height of between 90 and 65cm to avoid syphoning.
●Ensure the drain hose is securely attached, to prevent it coming away while the machine is in use and causing a flood.
hose clip
If the GREY drainage hose is too short:
A longer drainage hose is available from our Genuine Parts & Accessories Mail Order Hotline UK on 08709 077 077 (or in the Republic of Ireland on (01) 842 6836).
6