Hotpoint BWD 129 manual Care and maintenance

Page 16

Care and maintenance

Cutting off the water or electricity

GB supply

Turn off the water tap after every wash. This will limit the wear of your appliance's water system and also prevent leaks.

Unplug your appliance when cleaning it and during all maintenance operations.

Cleaning your appliance

The exterior and rubber parts of your appliance can be cleaned with a soft cloth soaked in lukewarm soapy water. Do not use solvents or abrasives.

Cleaning the detergent dispenser

1

2

Remove the dispenser by raising it and pulling it out (see figure).

Wash it under running water; this operation should be repeated frequently.

Caring for your appliance door and drum

Always leave the appliance door ajar to prevent unpleasant odours from forming.

Cleaning the pump

The Washer-dryer is fitted with a self-cleaning pump that does not require any maintenance.

Checking the water inlet hose

Check the water inlet hose at least once a year. If you see any cracks, replace it immediately: during the wash cycles, water pressure is very strong and a cracked hose could easily split open.

￿Never use hoses that have already been used.

￿"

Image 16
Contents Instructions for Installation and Use Page Instructions for use WASHER-DRYERUnpacking and levelling InstallationElectric and water connections 65 100 cm First wash cycle Blue Neutral N Brown Live L Green & Yellow Earth ETechnical details Instructions for the fitter Troubleshooting Service Washer-dryer description Control panelLeds Briefly starting a programme Starting and ProgrammesProgramme table Setting the temperature Variable Temperature PersonalisationsSet the drying cycle Drying Programme FunctionsDetergents and laundry Precautions and advice General safetyDisposal Saving energy and respecting the environmentCare and maintenance Troubleshooting Problem Possible causes/SolutionPage Guarantee After Sales Service