Hotpoint WDUD instruction manual Machine vibrates a lot during

Page 14

GB

The machine vibrates a lot during

the spin cycle.

The machine is noisy.

The machine wont spin properly.

The machine leaks from the dispenser.

The machine leaks (other than dispenser).

The machine is locked and an error code appears on the display (eg F-01, F-..).

The machine smells.

The machine door cannot be opened.

Door Seal damaged at the bottom.

The water level is too low when the machine is washing.

The word ‘DEMO ON’ appears in- termittently in the display window and the drum slowly turns.

The machine just ‘beeps’ when a programme or option is selected (Child Lock Symbol is lit).

There is too much foam.

After completing the programme, or before starting a programme, the ma- chine has turned itself off (no lights).

General.

The feet have not been adjusted, enabling the machine to rock.

New Installation - Either the Transit Bolts including the plastic spacers, or the

Polystyrene Packaging have not been removed when installing the machine.

The machine is trapped between cabinets and/or walls.

The load is in a slight out of balance condition and machine is spinning, but at a lower speed.

There will always be some motor, pump and drum noise during spin.

Out of Balance detected when attempting to go into a spin cycle - If this happens the ma- chine will continue to try to repeat the distribution of the load required before the machine will go into higher spin speeds - This will increase the programme time accordingly. This is a safety feature to prevent damage. Out of Balance can be caused by washing a single heavy item (eg duvet, quilt, etc). - Try the programme again using a different load.

The dispenser drawer is blocked with detergent and requires cleaning.

The water pressure is too high and requires turning down - turn down the tap on the water supply pipe slightly and try again.

The machine is tilting forwards - It must be level when in its final position.

The fill hose is loose, check both the cabinet and tap ends.

The fill hose is tight but still leaks, if so replace the rubber washers, or the fill hose is missing the rubber washer.

The drain hose is not fixed in properly.

Switch off the machine and unplug it, wait for approximately 1 minute and then switch it back on again If the problem persists contact the Technical Assistance Service.

The machine requires a service wash. Run a 90 degree wash cycle with deter- gent and no laundry.

The door will not open until the door lock indicator light goes out shortly after the program has finished.

If there is no power to the machine you need to perform the manual unlocking procedure (see Precautions & Tips).

The door seal has drainage holes at the bottom - This is normal.

The water level is correct if it can be seen at the bottom of the door.

To exit, switch machine off, then press and hold ‘START/PAUSE’ and ‘ON/OFF’ buttons simultaneously for 3 seconds.

Deactivate the Child Lock feature by pressing and holding in the ‘CHILD

LOCK’ button for 2 seconds.

The detergent is not suitable for machine washing (it should display the text ‘for washing machines’ or ‘hand and machine wash’ or the like).

Too much detergent was used - less detergent is required in soft water.

To comply with new energy saving regulations the machine is fitted with an automatic standby system. Press ‘ON/OFF’ button for 3 seconds to activate the machine, it can then either be switched off or a new programme selected.

Your washing machine contains sensors that monitor progress during the wash cycle (eg: Water Levels, Temperatures, Out of Balance loads, Wash time/progress). Normally, if your machine successfully completes the cycle, there is unlikely to be anything wrong!

Remember, you will be charged for a service call for problems caused by incorrect installation, as listed above. Not emptying contents from pockets may cause pump or drain blockages, or may damage the machine. Do not wash items which do not have a wash label, or wash items that are not intended as machine washable.

14

Image 14
Contents Instructions for use WASHER-DRYERElectric and water connections InstallationUnpacking and levelling 65 100 cm First wash cycle Bution boardTechnical data Description of the washer-dryer Control panelDisplay How to run a wash cycle or a drying cycle Wash functions Wash cycles and functionsTable of wash cycles Preparing the laundry Detergents and laundryDetergent dispenser drawer Special wash cyclesDisposal Precautions and tipsGeneral safety Opening the porthole door manuallyCleaning the pump Care and maintenanceCleaning the washer-dryer Cutting off the water and electricity GB suppliesPossible causes / Solutions TroubleshootingProblem Machine vibrates a lot during GuaranteeGB AssistanceAfter Sales Service 195098120.00

WDUD specifications

The Hotpoint WDUD series is a versatile and innovative range of washer-dryer machines designed to meet the needs of modern households. This appliance merges the capabilities of both washing and drying into one compact unit, making it highly convenient for those with limited space.

One of the standout features of the Hotpoint WDUD is its impressive energy efficiency. The model is engineered to meet high energy standards, providing users with the benefit of reduced utility bills while still delivering reliable performance. The machine incorporates an intelligent sensor that automatically adjusts cycle times in response to load size, ensuring optimal energy consumption.

In terms of capacity, the Hotpoint WDUD can handle laundry loads of up to 7 kg for washing and 5 kg for drying. This makes it suitable for smaller families or apartments where space is at a premium. The intuitive design allows users to easily switch between washing and drying modes, streamlining the laundry process.

The model features a variety of washing programs tailored to meet the specific needs of different fabrics. Whether you're dealing with delicate items, everyday cottons, or heavily soiled garments, the Hotpoint WDUD offers dedicated cycles that ensure your clothes are treated with care. Additionally, the machine is equipped with a rapid wash option, enabling users to clean lightly soiled items in a fraction of the usual time.

Hotpoint has also integrated advanced technologies into the WDUD series, such as the 'Anti-Stain' technology. This works by intelligently controlling the temperature and timing of the wash to tackle and eliminate common stains without the need for pre-treatment. The 'Fresh Care' option keeps laundry tumbling gently in the drum after the cycle has finished, preventing unpleasant odors and ensuring clothes remain fresh until you’re ready to unload them.

Furthermore, the Hotpoint WDUD is designed with ease of use in mind. The user-friendly control panel and clear display make selecting the desired cycle simple, even for those less technologically inclined. There is also an eco-friendly option that allows users to keep their environmental impact low while still achieving impeccable cleaning results.

In summary, the Hotpoint WDUD series is a blend of convenience, efficiency, and cutting-edge technology, making it a smart choice for anyone looking to enhance their laundry experience. Its compact design, various washing programs, energy efficiency, and advanced stain removal capabilities position the Hotpoint WDUD as an essential appliance for modern living.