Ariston S1200UK, S1200AUK manual Energy saving hints, General maintenance

Page 8
Unplug the machine when you go away
It’s best to unplug the machine when you go away, turn off the water supply and leave the machine door open or ajar. The drum and rubber door lining will dry and no unpleasant odours will form inside.
Detergent dispenser drawer
This can be removed and cleaned. Just pull it towards you, as shown in the diagram, and leave it under running water for a few minutes.

Energy saving hints

-Try to wash complete laundry loads: this saves unnecessary consumption of water and energy.

-Select the right programme for your laundry: this will obviously depend on the type of fabric and how soiled your laundry is; we recommend the use of programmes without prewash which will save you time, water and energy. The prewash cycle should in fact be used only for heavily soiled, cotton fabrics.

-Set the right temperature: use temperatures above 60°C only for very stubborn dirt but remember that modern detergents are very efficient even at low temperatures.

-Use the correct quantities of detergent: do not use too much detergent; remember that not only will this make rinsing more difficult but also pollutes the enviroment.

-Use the economy buttons: when washing small laundry loads use the Economy button if available on your washer and reduce the detergent quantity.

-Your washer features automatic consumption control, this means that you can wash laundry loads from 1 - 4,5 kg with considerable savings. Your washer will use just the right amount of water and electricity. All you need to do is dose the detergent.

-Fabric softeners: always use a softener; not only do these perfume and soften your laundry, they also make it easy to iron, saving you time.

General maintenance

After every wash

Leave the door open and wipe the door gasket dry after each wash so that damp or odours do not form.

Remove the plug

Before cleaning or servicing always remove the plug from the socket. This is for safety reasons.

No solvents or abrasive substance

You do not need solvents or abrasive substances to clean the outside of the washing-machine and the rubber parts. Just use a cloth, warm water and soap.

When moving house

When you move, all you need to do is secure the inside of the machine with the transit screws (supplied with the packaging of the machine) so that it will not be damaged.

Cleaning and special servicing

Hose

Check the hose once a year. It should be replaced if any signs of splitting or damage can be seen. The machine is under a lot of strain while operating and this may cause a cracked hose to split open suddenly.

1

Inspecting the drain pump

 

Your washer has a self-cleaning pump and therefore requires

 

no cleaning or mainteannce. Remember however that small

 

items such as buttons or coins may accidentally fall into the

2

pump. To remove these items, the pump comes equipped

with an "prechamber" which is accessible from the front of

the pump.To gain access to this prechamber simply remove the panel located on the bottom part of the washer (figure 1), place it on the ground near the machine (figure 2), and remove the lid by turning it in the counter clockwise direction. Carefully inspect the inside of the pump. Important: before removing the lid check that the wash cycle has ended and unplug the washer from the mains. It is normal for a small quantity of water to spill out once the lid is removed.The panel positioned at the base of the machine will catch the water that spills out. Remember to shut the lid firmly when you replace it.

7

GB

Image 8
Contents Instruction booklet EnglishSafety, a good habit to get into Saves while it washesControlled consumption Double-action washOverview Using your washer Alternate small and large items when loading your washerPreparing your laundry Check wash labelsRun the first wash without laundry using programme 2 at 90C Starting up your washerAt the end of the wash cycle Selecting the programmeSelecting the programmes Heavy FabricsWashing tips General maintenance Energy saving hintsTrouble shooting Installation Transit packingLevelling Water supplyElectrical connection figure Technical characteristics Com pliance