Ariston CDE 12x manual Margheritashould not be, Installed in an outdoor, Environment, not even

Page 17

More and more important

M ARGHERITA

Your safety and that of

your children Margherita has been built in compliance with the strictest international safety regulations. To protect you and all your family.

Read these indications and all the information in this manual carefully: they are an important source, not only of numerous useful tips, but also of vital information on safety, use and maintenance.

1. Margheritashould not be

installed in an outdoor

environment, not even

when a roof shelters the

area, because it may be

very dangerous to leave it

exposed to rain and

thunderstorms.

2. It must only be used by

adults and exclusively for

5.Never touch the washer- dryer when barefoot or with wet or damp hands or feet.

6.Never use extensions or multiple plugs, which are particularly dangerous in humid environments. The power supply cable must never be bent or dangerously compressed.

7.Neveropenthedetergent dispenser while the appliance is functioning; do not use hand wash detergent because the abundance of foam could damage its internal parts.

8. Never pull on the plug or

the washer-dryer to

disconnect it from the wall

socket: it is extremely

dangerous.

 

9. While the appliance is

functioning, do not touch

the drain water

as it

could reach very

high

temperatures.

The

appliance door, during

wash cycles, tends to

become heated; keep it

out of children’s reach.

Never force the washer-

dryer door because this

could damage the safety

washig clothes following

theinstructionsprovidedin

this manual.

3. Shouldithavetobemoved,

proceed with the help of

two or three people and

handle it with the utmost

care. Never try to do this

alone, because the

appliance is very heavy.

4. Before loading the washer-

dryer, make sure the

drum is empty.

I only want an authorised specialised technician with original Ariston spare parts!

block on the

opening,

which serves to protect

from accidental openings.

10. In case of malfunctio-

ning, first close the

water tap and unplug the

appliance from the wall

socket; do not under any

circumstances

touch

internal parts in order to

attempt repairs.

 

How to change the power supply cable

The Margherita power supply cable is special and can be purchased

exclusively from authorised Technical Service Centres.

To replace the cable:

1.Make sure that Marghe- rita is switched off and unplugged.

2.Remove the cover by unscrewing screws I [fig 13].

3.Disconnect the wires from the radio interference suppressor F [fig. 14] noting as to their position (Blue=N wire; Brown=L wire) leaving the earth wire until last . N.B.: letters L, N and the symbol are indicated on the radio interference suppressor.

4.Remove the screw and washer V [fig. 15], which act as a stop for the cable passageway.

5.Remove the upper part of the cable slightly from the back panel of the appliance, pull the power supply cable

upwards and take it out [fig. 16].

To connect the new power supply cable, reverse the pro- cedure.

It is important for your safety that you reassemble all parts and screws used.

N

L

F

Fig. 13

Fig. 14

Fig. 15

Fig. 16

Margherita - Iinstructions for installation and use 16

Image 17
Contents Margherita That the electric system complies with the law Big and small happily together Before washingUse this knob to select the wash programme Knob a to symbolFabric softeners If you60C 90C40C 50CDry only Combined Washing and Drying ProgrammeDoor is shut correctly TheplugisinsertedinthesocketGarmentsthewaytheydeserveto Dry cleaningBe treated Salopette alert Watch the weightHolidays unplug the appliance Curtains Quilted coats and wind TrainersRecommended When you bleach during aCycle Wash itemsIs the washer-dryer door closed properly? Is there electricity in the house?Is the On/Off button pressed? Is the hose’s mouth immersed in water?Washer-dryer vibrates too much during the spin cycle Washer-dryer does not drain or spinWasher-dryer leaks Too much foamReplacement fuse covers Connecting the drain hoseLevelling Connection to the water mainsAmpere re-wearable plug bearing the BSI mark of approval. or Removing the plugInstructions for the fitter Door Mounting AccessoriesThis is how to assemble the plinth guide Using the Drilling TemplateAccessories provided for the height adjustment Mounting the Parts onto the Face of the MachineNever exaggerate with doses Treat her well and she’ll be yourWhen a roof shelters Installed in an outdoorMargheritashould not be Environment, not evenStay in touch Argherita