Ariston CD12TUK manual Electrical connection figure

Page 12

Electrical connection (figure 8)

Your appliance is now supplied with a 13 amp fused plug it can be plugged into a 13 amp socket for immediate use. Before using the appliance please read the instructions below.

WARNING -THIS APPLIANCE MUST BE EARTHED.

THEFOLLOWINGOPERATIONSSHOULD BECARRIEDOUT BYAQUALIFIEDELECTRICIAN.

Replacing the fuse:

When replacing a faulty fuse, a 13 amp ASTA approved fuse to BS 1362 should always be used, and the fuse cover re- fitted. If the fuse cover is lost, the plug must not be used until a replacement is obtained.

Replacement fuse covers:

If a replacement fuse cover is fitted, it must be of the correct colour as indicated by the coloured marking or the colour that is embossed in words on the base of the plug. Replacements can be obtained directly from your nearest Service Depot.

Removing the plug:

If your appliance has a non-rewireable moulded plug and you should wish to re-route the mains cable through partitions, units etc., please ensure that either:

the plug is replaced by a fused 13 ampere re-wearable plug bearing the BSI mark of approval.

or:

the mains cable is wired directly into a 13 amp cable outlet, controlled by a switch, (in compliance with BS 5733) which is accessible without moving the appliance.

Disposing of the plug:

Ensure that before disposing of the plug itself, you make the pins unusable so that it cannot be accidentally inserted into a socket.

Instructions for connecting cable to an alternative plug: Important: the wires in the mains lead are coloured in accordance with the following code:

Green & Yellow Earth

BlueNeutral

Brown Live

As the colours of the wires in the lead may not correspond with the coloured markings identifyng the terminals in your plug, proceed as follows:

Connect Green & Yellow wire to terminal marked E or or coloured Green or Green & Yellow.

Connect Brown wire to terminal marked L or coloured Red. Connect Blue wire to terminal marked N or coloured Black. If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse, either in the plug or adaptor or at the distribution board.

If you are in any doubt the electrical supply to your machine, consult a qualified electrician before use.

How to connect an alternative plug:

The wires in this mains lead are coloured in accordance with

the following code:

 

BLUE

NEUTRAL (N)

BROWN

LIVE (L)

GREEN&YELLOW EARTH (E)

Disposing of the appliance:

When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above.

GREEN &

YELLOW

BROWN

13 ampere fuse

 

BLUE

CROSS-BAR

 

CORD GRIP

Fig. 8

11

GB

Image 12
Contents Ariston BUILT-IN Washer Dryer Safety, a good habit to get into MargheritaSaves while it washes Controlled consumptionOverview Using your washer-dryer Starting up your washer-dryer Selecting the programmeAt the end of the wash cycle Drying onlyNow select the programme At the end of the drying cycleWashing and drying Selecting the programmes MAXWashing tips General maintenance Energy saving hintsTrouble shooting Installation Connecting the drain pipeTransit packing LevellingElectrical connection figure Door Mounting Accessories Fig Mounting the Parts onto the Face of the MachineHinge Supports Hinges Magnet Rubber plug Magnet plateTechnical characteristics Using the Drilling TemplateMounding the Parts onto the Wooden Panel Door Mounting the Panel into the machine