Energy saving hints, General maintenance

Energy saving hints

-Try to wash complete laundry loads: this saves unnecessary consumption of water and energy.

-Select the right programme for your laundry: this will obviously depend on the type of fabric and how soiled your laundry is; we recommend the use of programmes without prewash which will save you time, water and energy. The prewash cycle should in fact be used only for heavily soiled, cotton fabrics.

-Set the right temperature: use temperatures above 60°C only for very stubborn dirt but remember that modern detergents are very efficient even at low temperatures.

-Use the correct quantities of detergent: do not use too much detergent; remember that not only will this make rinsing more difficult but also pollutes the enviroment.

-Use the economy buttons: when washing small laundry loads use the Economy button if available on your washer- dryer and reduce the detergent quantity.

-Your washer-dryer features automatic consumption control, this means that you can wash laundry loads from 1 - 5 kg with considerable savings.Your washer-dryer will use just the right amount of water and electricity. All you need to do is dose the detergent.

-Fabric softeners: always use a softener; not only do these perfume and soften your laundry, they also make it easy to iron, saving you time.

General maintenance

After every wash

Leave the door open and wipe the door gasket dry after each wash so that damp or odours do not form.

Remove the plug

Before cleaning or servicing always remove the plug from the socket. This is for safety reasons.

No solvents or abrasive substance

You do not need solvents or abrasive substances to clean the outside of the washer-dryer and the rubber parts. Just use a cloth, warm water and soap.

When moving house

When you move, all you need to do is secure the inside of the machine with the transit screws (supplied with the packaging of the machine) so that it will not be damaged.

Cleaning and special servicing

Hose

Check the hose once a year. It should be replaced if any signs of splitting or damage can be seen. The machine is under a lot of strain while operating and this may cause a cracked hose to split open suddenly.

	Detergent dispenser	1
	drawer	1
	drawer
	This can be removed and
	cleaned. Just pull it towards
	you, as shown in the diagram,	2
	and leave it under running	2

water for a few minutes.

Unplug the machine when you go away

It’s best to unplug the machine when you go away, turn off the water supply and leave the machine door open or ajar. The drum and rubber door lining will dry and no unpleasant odours will form inside.

Inspecting the drain pump

Your washer-dryer is equipped with a self-cleaning pump, and, therefore, does not require maintenance or cleaning. However, certain types of objects might find their way into the pump (e.g. buttons, coins, etc.). Since they are too large to be expelled through the drain pipe, they will be trapped in the “antechamber” of the pump, which is accessible from the front of the pump itself. To gain access to this compartment, simply remove the finishing strip on the base of the cabinet (Fig. 1), remove the Z screw (Fig. 2) with a screwdriver and take off the cover of the pump. Then carefully inspect the interior.

Caution: Before removing the cover, make sure that the wash cycle has finished completely. Then, turn off the machine by, switching the ON/OFF button I to the O setting. It is normal for a small quantity of water to escape after the cover has been removed.When you replace the cover, make sure that it is closed tightly.