Signals for successive refilling:
Once, at the end of a cycle, the level of detergent/fabric softener falls below the level required for a successive wash cycle, the display will visualise the relative messages “At end of cycle refill detergent” or “At end of cycle refill softener” or “At end of cycle refill tanks”. If the tanks are not filled, the successive wash cycles in Auto Dose System will be carried out without any intake of detergent.
!We suggest adding detergent and fabric softener ONLY after the machine’s signal.
!NEVER mix two different detergents; always clean out the tank before adding a new type of detergent (refer to “Cleaning cycle set by the user”).
Using the “Auto Dose System”
If the compartments have been filled with detergent and fabric softener, you may start using the machine (refer to “Running a wash cycle”).
Powder detergents for
Whenever bleaching is required, pour the bleach in the
Automatic cleaning:
The washing machine carries out an automatic cleaning EN cycle during the rinse cycle if the level of detergent that
remains is insufficient for carrying out a successive wash cycle.
Cleaning cycle set by the user:
Run the cleaning cycle (with empty drum) if you require adding a different product to the previous one or if the tanks have been incorrectly filled (e.g. fabric softener has been erroneously poured into the detergent tank or
Press button 
and hold for 5 sec. to activate cleaning of the detergent tank, button 
for cleaning the fabric softener tank or button 
for cleaning both tanks. Keep pressing for a further 3 sec. (the countdown
The cleaning cycle lasts about 40’ if the tanks are initially empty; if not, the cycle will last longer. The icons indicating that the tanks are empty will appear on the display.
“Traditional” mode
Pull out the detergent dispenser drawer up to the first stop point (see picture) then pour the amount of detergent and other additives (e.g. bleach) required for a single wash cycle directly into the dispenser.
relative compartment (refer to the option “Super Wash”).
Modifying
The machine automatically intakes detergent on the basis of the selected programme, wash load and water hardness. However, the amount of detergent/fabric softener used may be modified.
button: press to increase, decrease and to exclude detergent intake.
| 1 |
2 | 3 |
|
1.pre-wash compartment: use powder detergent only.
2.main wash compartment: use powder or liquid detergent. If the latter is used, we recommend pouring it into the dispenser immediately before starting the washing machine and without running a pre- wash cycle.
button: press to increase, decrease and to exclude fabric softener intake.
The level of detergent/fabric softener suggested by the machine is indicated by 3 bars.
Less than 3 bars indicates a lower level of detergent/ fabric softener compared to that suggested by the machine, while more than 3 bars indicates a higher level of detergent/fabric softener.
Cleaning the tanks:
Tank cleaning cycles can either be automatic or
3.bleach compartment: to be used whenever bleaching is required (refer to “Super Wash” option).
Tablet detergent or the relative “laundry ball” must be added directly inside the drum. In this event, deactivate the “Auto
Dose System” (by pressing the 
button until the relative vertical bars disappear from the display).
Do not pour any fabric softener as the appropriate quantity required for each wash cycle will be automatically extracted.
To deactivate fabric softener intake, press the 
button until the vertical bars disappear from the display.
For wool and silk garments, we recommend using a special detergent which must be poured directly into the detergent dispenser (compartment 2).
Running the wash cycle:
Select the programme and the compatible options on the basis of the required need and type of load.
9