2.05
While the programme is running (after you have pressed the START/PAUSE button), the displayed time value decreases by one unit every minute.
•Selected drying time in minutes or hours and minutes.
1.25
After the programme has started the time remaining is updated every minute.
•The washing machine has stopped with water in the tub, at the end of a programme with the RINSE HOLD option: this is indicated by a static zero.
•The washing machine has completed the programme: this is indicated by a blinking zero. At the same time, the door locked light goes out. The zero will reappear when you switch the washing machine on, unless the previous programme has been erased by means of the SKIP RESET button.
•Delay start, a time value indicated in hours and selected by means of the relevant button.
The delay time is displayed for 3 seconds, then the duration of the selected programme reappears.
After you have pressed the START/PAUSE button, the countdown begins, and the delay time value decreases by one unit every hour.
You can delay the start of the selected programme by up to 24 hours in one hour intervals.
•An incorrect option selection has been made: this is indicated by the message Err when a function incompatible with the current programme is selected.
The incorrect selection is also indicated by an audible warning signal.
•An alarm code indicates a fault in the machine operation (see the relevant chapter on page
0
Important!
The first time you use the washing machine, when you switch it on, it may display a blinking zero and give an audible warning signal. This is due to the fact that the washing machine has performed a washing cycle during the manufacturer’s inspection tests, and this cycle has not been erased after its completion.
E20
8