10 START/PAUSE button 
This button has three functions:
•Start: after you have selected the desired programme and options, press this button to start the machine. The light above the button will stop flashing and remain lit.
If you have selected a delay time by means of button 12, the countdown will begin and will be shown on the display.
•Pause: when you press this button again, the programme in progress is interrupted. The light above the button will start flashing. To restart the programme, press the button again.
When you PAUSE the cycle, the DOOR LOCKED light goes out, and it becomes possible to open the door, provided
•the machine is not in the heating or drying phase;
•the level of the water is not high;
•the drum is not turning.
Important! You must set the washing machine to PAUSE before you make any change in the programme in progress.
•Draining of water and spinning after the execution of programmes with the RINSE HOLD option.
A normal wash cycle consists of the following phases, Wash - Rinses - Spin and is confirmed by the illumination of the corresponding LED,s.
PREWASH
WASH
RINSES
SPIN
DRAIN
DRYING
To select rinse & spin, press the SKIP button once, the wash LED goes out.
To select spin only, press the SKIP button twice. The wash & rinse LED,s go out.
11 SKIP/RESET button
This button performs two functions:
-Clears the memory
-Selects special programmes
At the end of every programme the RESET button must be pressed once or repeatedly to clear the programme memory. This will be confirmed by three dashes, flashing in the display.
If the previous programme is not cleared, the display will show a “0” flashing and an audible signal will sound, when you switch the machine on.
Selecting a special programme:
A wash programme must be selected in the normal way. (START button not pressed)
To select Drain press the SKIP button three times, the wash - rinse - spin LED,s go out.
S
T
A
R
T
| E |
S | |
/PAU |
|
If you wish to cancel or advance the running programme to the required phase, PAUSE the cycle and then press the SKIP button as previously described.
9