7.Select the spin speed or the RINSE HOLD option
Press the SPIN SPEED button repeatedly, in order to select the desired spin speed or the RINSE HOLD option. The relevant light will light up.
If you select the RINSE HOLD option, the machine will stop at the end of the programme with the water still in the tub.
1200
900
700
500
RINSE
HOLD
P |
|
| ED | |
S | I | E | ||
|
| N SP |
| |
8. Select the desired options
If your laundry is very dirty, it may be advisable to select the PREWASH option.
If your laundry is lightly or normally soiled and it is necessary to prolong the washing time, select the AA40° option.
If your laundry is only slightly soiled, select the QUICK option. The relevant light illuminates.
PREWASH
AA40°
QUICK
O | S |
| PTION |
9. Start the programme
Press the START/PAUSE button. The relevant light will stop flashing, the DOOR LOCKED light will light up, and only the light relevant to the phase that is in progress will remain lit.
ST | S | |
| ART/PAU | E |
|
| |
10.How to change a programme during its cycle
Before you make any change, you must pause the washing machine by pressing the START/PAUSE button.
It is possible to change any phase before the programme carries it out.
Changing the type of fabric or temperature is possible, obviously, only during the washing phase. When you make a change in these two parameters, the washing machine will resume the cycle from the beginning.
If it is necessary to drain the water in order to change the programme in progress, proceed as follows:
•PAUSE the machine by pressing the START/PAUSE button;
•press the SKIP/RESET button repeatedly, until only the DRAIN light remains lit;
•press the START/PAUSE button again.
When the water has been drained, you may now select a new programme and press the START/PAUSE button to start it.
11.How to cancel a programme during its cycle
To cancel a programme that is being carried out, first pause the washing machine by pressing the START/PAUSE button, then press the SKIP/RESET button repeatedly, until the phase indicator lights go out.
12.How to open the door during the cycle of a programme
You can open the door, after having set the washing machine to PAUSE, provided the following conditions exist:
•the washing machine is not in the heating phase beyond 55°C;
•the level of the water is not high;
•the drum is not turning.
If these requirements are met, when you pause the washing machine, the DOOR LOCKED light goes out and the door can be opened.
Should it not be possible to open the door, and should it be absolutely necessary to do so, switch the machine off by pressing the ON/OFF button.
After approximately 3 minutes, you can open the door.
10