Door reversal
The opening direction of the outer door on this washing machine can be reversed. To carry out this operation, proceed as follows:
1)Disengage the end of the catch (1) from the door and turn it through 90° to remove it from its seat (Fig. A).
2)Using a screwdriver, turn plastic plug (2) through 90° to remove it from its seat (Fig.
3)Fit plug (2) in the hole left free by catch (1) and turn it through 90° to lock it in place (Fig. B).
4)Fit catch (1) into the hole from which plug (2) was removed and turn it through 90°, making sure that the latching tooth is facing towards the right (Fig. B).
5)Remove the door by unscrewing the screws securing it to the bottom hinge (3 - Fig. A).
6)Unscrew the two plastic screws (4 - Fig. A) and fit them on the opposite side (4 - Fig. B).
7)Remove the catch hook (5 - Fig. A) by inserting a screwdriver into the upper hole and pushing downwards.
8)Remove plate (6) by inserting a screwdriver into the bottom hole and pushing upwards (Fig. A).
9)Refit the catch hook (5) and plate (6) on the opposite sides (Fig. B).
10)Remove the door catch (7) and plate (8) as explained in paragraph 7.
11)Turn the door through 180°.
12)Refit the door catch (7) and plate (8), reversing their position and pressing firmly to engage the hook (Fig. B).
13)Fit the door onto the washing machine. Insert the top pin first, then the bottom pin into the hinge (3- Fig. B); finally screw the hinge onto the washing machine.
14)Check that the door is aligned with the appliance. To do this, loosen screw (9 - Fig.
B)by a couple of turns and
15)Fit the flexible end of the door catch
(1 - Fig. B) into the location provided in the door.
| 6 |
7 | 2 |
5 |
8 | 4 |
|
P0534 | 1 9 3 | A |
|
| 1 | ENGLISH |
|
|
| |
5 | 6 |
| 7 |
2 |
|
| 8 |
4 |
|
| |
|
|
| |
P0535 | 3 9 |
| B |
Fitting a door panel
The door of this washing machine has mouldings to allow fitting of a decorative panel (stainless steel sheet, laminated plastic, wood etc.) to match with the existing kitchen units.
The dimensions of the panel must be as follows:
Width | 588 mm |
Height | 588 mm |
Maximum thickness | 004 mm |
To fit the panel, remove the moulding by unscrewing its fixing screws. Position the panel, then refit the moulding, making sure that it comes into contact with and firmly clamps the panel.
27