Zanussi FL 1014 V1 instruction manual Something not Working, Problem Possible cause

SOMETHING NOT WORKING

Problems which you can resolve yourself

■	Problem		Possible cause
■	The machine does not start up:	■	Check that the door is firmly closed.
		■	Check that the machine is plugged in and
			that there is power at the socket.
		■	Check that the main fuse has not blown.
		■	Check that the programme selector dial is
			positioned correctly and that the start/stop
			button has been depressed.
■	The machine does not fill:	■	Check that the water tap is open.
		■	Check that water is coming out of the tap.
		■	Check that the inlet hose is not squashed or
			kinked.
		■	Check that the filter in the inlet hose is not
			blocked.
		■	Check that the door is closed.
■	The machine fills then empties	■	The end of the drain hose is too low. Refer to
	immediately		relevant paragraph in “water drainage”
			section.
■	The machine does not empty	■	Check that the drain hose is not squashed or
	and/or does not spin:		kinked.
		■	The drain filter is blocked. Clean it.
		■	The anticrease or no spin option has been
			selected.
		■	The wash load is unbalanced.
			Redistribute the clothes inside the drum to
			allow the machine to spin.
■	There is water on the floor:	■	Too much detergent or unsuitable detergent
			(creates too much foam) has been used.
		■	Check whether there are any leaks from one
			of the inlet hose fittings. It is not always easy
			to see this as the water runs down the hose;
			check to see if it is damp.
		■	Check that the drain hose is not damaged.
		■	Check that the drain filter has been refitted
			correctly after cleaning.
■	Unsatisfactory washing results	■	Too little detergent or unsuitable detergent
			has been used.
		■	Stubborn stains have not been treated prior
			to washing.
		■	The correct temperature or programme was
			not selected.

38