Zanussi T 733 V manual For the Installer, Unpacking

Page 18

FOR THE INSTALLER

Technical information

Dimensions

height with panel

895 mm

 

height without panel

850 mm

 

width

397 mm

 

depth

600 mm

Power supply voltage / frequency

230 V / 50 Hz

Total power absorbed

 

2300 W (10 A)

Heater rating

 

1950 W

Water pressure

minimum

0,05 MPa (0,5 bar)

 

maximum

0,8 MPa (8 bar)

Maximum load

cotton

5,0 kg

 

synthetics

2,5 kg

 

wool

1,0 kg

Spinning speed

Cotton, synthetics, wool

 

 

- T 733 V

from 300 to 750 rpm

 

- T 833 V

from 300 to 850 rpm

 

Delicates

from 300 to 650 rpm

This appliance complies with the following EC Directive :

-72/23/EEC of 19.02.1973 - Low-Voltage Directive.

-89/336/EEC of 03.05.1989 (including Amentment Directive 92/31/EEC) - EMV Directive.

Installation

Unpacking

The parts protecting the inner components of the machine during transit must all be removed before using your machine for the first time. These parts and their securing means should be kept in case the machine has to be transported again.

Unpack the appliance. Tilt the appliance backwards. Give to one of the back corners a quarter turn. The appliance comes free naturally out the polystyrene basis. Take away this basis (fig. 1).

Open the lid of the appliance and remove the polystyrene and plastic wedges which block the drum. Close the lid (fig. 2).

On the back part and with a spanner, remove the two loosened spacers (A) (fig. 3).

The holes which are now visible must be closed with the plugs (B) provided with the appliance (fig. 4).

Please ensure that these parts have been removed from the machine and keep them in case of next transport (fig. 5).

If you want to keep the alignment of your appliance with the adjacent cupboards, you have the possibility to cut the crossbar holding the hoses located at the back of your washing machine (fig. 6).

Fig. 1

Fig. 2

B

 

 

A

 

 

 

 

 

 

+"#3￿￿￿

Fig 3

 

 

 

 

 

 

 

 

Fig 4

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Fig 5

Fig 6

38

Image 18
Contents Zanussi Contents Safety Instructions InstallationUse Safeties Environmental informationSymbols Description of the ApplianceDetergent dispenser USE of Your Appliance Measure out the detergent Operating InstructionsPlace the laundry in the drum Add the bleach agent, if requiredSelect the programme Select the temperatureSelect the spinning speed Starting of the programmeProgrammes Chart Programmes for cotton/linenProgrammes for synthetics/delicates/wool Maximum loads 2,5 kg synthetics, 1 kg woolHints and Tips Powder detergents At the end of the washingDetergents and additives Liquid detergentsWasch code symbols Cleaning and Maintenance BodyworkDrain filter If Something Doesnt Work ? There is water on the floor Problems Solutions Machine vibrates or is too noisyMachine empties as it fills Softener detergent flows out the overflowService Data plateProtection against pests For the Installer UnpackingLevelling Moving of the applianceWater connection Electrical connection05/02