Zanussi F1003 W manual Electrical connections, Permanent connection

Page 26

Electrical connections

Any electrical work required to install this appliance should be carried out by a qualified electrician.or competent person

WARNING: THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should this safety measure not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate(the plate is adhered to the rear of the appliance).

The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1363A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires in the mains lead are coloured in accordance with the following code:

Green and Yellow

- Earth

Blue

 

- Neutral

Brown

 

- Live

GREEN & YELLOW

 

 

E

 

 

13 A

 

 

L

 

 

N

 

 

BROWN

 

BLUE

 

 

P1041

CORD CLAMP

 

 

 

The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the earth symbol or coloured green and yellow.

The wire coloured blue must be connected to the terminal marked «N» or coloured black.

The wire coloured brown must be connected to the terminal marked «L» or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

WARNING:

A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard.

Ensure that the cut off plug is disposed of safely.

Should the appliance power supply cable neeed to be replaced, this should be carried out by our Service Force Centre.

Note

When the appliance is installed the power supply cable must be accessible.

Permanent connection

In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

26

Image 26
Contents Washing Machine Use InstallationChild Safety Contents Interest Environment Your New Washing MachineEcological hints Description of the Appliance Detergent dispenser drawerControl Panel Operating Sequence Start the machine At the end of the programmeWashing 2 KG of Mixed Fabrics AT 50C At the end of the programme Washing Hints 1000g = 1 kgWhich detergent? Which form?Wash Care Symbols Important NotesWashing Programmes Type of laundryProgrammes for synthetics, mixed fabrics, delicates and wool Maintenance and Cleaning Cleaning the water inlet filters Emergency emptying outSomething Not Working Customer Care Service & Spare Parts0870 5 European guarantee Guarantee ConditionsStandard guarantee conditions ExclusionsInstallation Instructions Technical SpecificationsUnpacking Water inlet PositioningWater drainage Interest of the environment LevellingSpecial conditions Electrical connections Permanent connectionPage From the Electrolux Group. The world’s No choice