Zanussi IZ 12 manual Operating Sequence, Load the laundry, Switch the machine on

Page 10

Operating Sequence

Before the first wash, we recommend that you run a cotton cycle at 60°C, without any laundry in the machine, to remove any manufacturing residue from the drum and tub.

Pour 1/2 a measure of detergent into the dispenser drawer and start the machine.

1.Load the laundry

Open the door.

Place the laundry in the drum, one item at a time, shaking them out as much as possible.

Close the door.

4. Switch the machine on

Press the ON/OFF button to switch the machine on. The display will show three blinking dashes or a blinking zero. The light above the button will light up.

 

/

O

 

0

N

F

 

O

 

 

 

 

 

 

F

 

---

P1084

2.Measure out the detergent

Pull out the dispenser drawer until it stops. Measure out the amount of detergent required and pour it into the main wash compartment .

If you wish to carry out the prewash, pour detergent into the appropriate compartment marked .

3.Measure out the fabric softener

5.Select the desired programme/ fabric

Press the FABRIC button repeatedly, in order to select the desired programme/fabric. The relevant light will light up.

The lights relevant to the phases that form the programme will light up.

The display will show the duration of the selected programme, calculated on the basis of the maximum load for each type of fabric. The START/PAUSE button light will start flashing.

If the load of laundry to be washed is small, at the beginning of the cycle the display will still indicate the duration relevant to the maximum load. The duration value will be gradually adjusted during the execution of the cycle.

If required, pour fabric softener into the compartment marked , without exceeding the «MAX» mark.

COTTONS

SYNTHETICS

PREWASH

C0064

C0065

DELICATES

WOOL

HAND

WASH

F

C

ABRI

WASH

RINSES

SPIN

DRAIN

Close the drawer gently.

10

Image 10
Contents Washing Machine Child Safety InstallationUse Contents Ecological hints Your New Washing MachineInterest of the environment Door locked light Child safety featureDescription of the Appliance Detergent dispenser drawerControl Panel Display Options buttonTime Save button Drain onlySTART/PAUSE button SKIP/RESET buttonSelecting a special programme Programme phase indicator lights Delay buttonYou can change the delay time at any moment, before Load the laundry Switch the machine onOperating Sequence Measure out the detergentSelect the spin speed or the Rinse Hold option Select the temperatureSelect the Delay Time Select the desired optionsHow to change a programme during its cycle End of programme«JETSYSTEM» wash 1000g = 1 kgWhich detergent? Which form?Wash Care Symbols Important NotesWashing programmes Maintenance and Cleaning Emergency emptying out Water inlet filterSomething Not Working 0870 5 Service & Spare PartsSymptom Possible causes Customer CareEuropean guarantee Zanussi Guarantee ConditionsStandard guarantee conditions This guarantee does not coverWay 3AE Installation Instructions Technical SpecificationsPositioning Installation on a Suspended FloorUnpacking Water inletWater drainage Levelling Special conditionsElectrical connection Permanent connectionFrom the Electrolux Group. The world’s No choice