132985450.qxd 18/07/2005 17:47 Pagina 9
The 
(DOOR) pilot light indicates if during the washing cycle the door can be opened:
•Light on: the door can be opened
(when the washing machine is set to PAUSE, the 
(DOOR) pilot light will go off).
•Light off: the door cannot be opened
(when the washing machine is set to PAUSE, the 
(DOOR) pilot light will start to flash)
The 
(END) pilot light flashes in the event of operating problems and the corresponding alarm code appears on the display.
E10 = the machine does not fill
E20 = the machine does not empty
E40 = the door has not been closed
To eliminate the problem, see paragraph “Something not working”.
If the 
(FILTER CLOGGED) pilot light flashes at the end of the programme this means that the drain filter must be cleaned.
Functions
End of programme
When the 
(END) pilot light on the programme progress display illuminates, if the 
(DOOR) pilot light has gone out, the the door can be opened (if the 
(RINSE HOLD) option has not been selected).
Turn the programme selector dial to X.
Switch the machine off by depressing the ON/OFF button before removing the laundry.
Altering an option or a running programme
It is possible to change any option before the programme carries it out.
Before you make any change, you must pause the washing machine by pressing the START PAUSE button.
Changing a running programme is possible only by resetting it. Turn the programme selector dial to "X" and then to the new programme position. The washing water in the tub will not emptied out .
Start the new programme by depressing the START PAUSE button.
14 Programme selector dial
The selector is divided into 5 sections:
•COTTON,
•SYNTHETICS
•DELICATES
•WOOL 
(hand washing)
•Special programmes
•Reset programme X
SPECIAL | X | 95º | COTTON |
| 60ºE | ||
|
|
| 60º |
|
|
| 40ºE |
|
|
| 40º |
|
|
| 30º |
WOOL |
|
| 60º |
30º |
|
| |
40º |
|
| 60ºE |
30º | 40º | 30º | 40º |
DELICATES |
|
| SYNTHETICS |
The selector dial can be turned either clockwise or anticlockwise.
Position E corresponds to the ENERGY SAVING programmes and position 
to “cold wash”.
At the end of the programme the selector dial must be turned to position X (reset).
Interrupting a programme
Depress the START PAUSE button to interrupt a programme which is running: the corresponding light starts to flash.
Depress the same button to restart the programme.
Opening the door after the programme has started
You can open the door, after having set the washing machine to PAUSE, provided the following conditions exist:
•the washing machine has not heated beyond 55°C;
•the level of the water is not high;
•the drum is not turning.
If these requirements are met, the 
(DOOR) pilot light will be on and, when you pause the washing machine, it will goes out: the door can be opened.
Should it not be possible to open the door, and should it be absolutely necessary to do so, switch the machine off by pressing the ON/OFF button.
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperatures of the water in the washing machine!
When you close the door and press the ON/OFF button again, the washing machine will resume the programme from the point where it had been interrupted.
9