Zanussi ZDE 47100W user manual Electrical connection, Door reversal, Special accessories

Page 13

longer drying times and higher energy consumption. If the hose is completely squashed, the safety cut-outs with which the machine is fitted may operate. When operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance.

Electrical connection

Details on mains voltage, type of current and the fuses required should be taken from the rating plate. The rating plate is fitted near the loading aperture (see “Product de- scription” chapter).

Connect the machine to an earthed socket, in accordance with current wiring regulations.

Warning! The manufacturer declines any responsibility for damage or injury through failure

to comply with the above safety precautions. Should the appliance power supply cable need to be replaced, this must be carried out by our Service Centre.

The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved BS 1363/A fuse must be used.

The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the earth

symbol or coloured green and yellow.

The wire coloured blue must be connected to the terminal «N» or coloured black.

The wire coloured brown must be connected to the ter- minal marked «L» or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

Warning! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard.

Ensure that the cut off plug is disposed of safely.

Warning! The plug must be accessible after installing the machine.

Permanent connection

In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current elec- trical regulations.

The switch must not break the yellow and green earth cable at any point.

Door reversal

To make it easier to load or unload the laundry, the door can be reversed. The door must only be reversed by an authorised service engineer. Please contact your local Service Force Centre. The engineer will carry out the door reversal at your cost.

1

3

2

Special accessories

Stacking kit

A special stacking kit is available through your deal- er, to enable the mounting of

The wires in the mains lead are coloured in accordance with the following code:

1Blue - Neutral

2cord clamp

3Brown - Live

4Green and Yellow - Earth

the dyer on top of a front loading washing machine with cover’s depth between 48 and 60 cm. Read carefully the instructions supplied with the kit.

13

Image 13
Contents Tumble Dryer ZDE 47100W Important safety information ContentsChild safety InstallationUse Control Panel Product descriptionBefore first use Laundry weightsSorting and preparing laundry Sorting laundryProgrammes Programme chartDaily use Switching machine onDoor opening and laundry loading Cleaning and maintenance Cleaning the door Cleaning fluff filterCleaning the drum Clean operating screen and housingBuzzer Signal permanent on/off Machine settingsInstallation Technical dataAppliance positioning Fitting the vent hose Removing transport safety packagingElectrical connection Special accessoriesDoor reversal Environment ServicePackaging material Environmental tipsPage 136909160-01-02022009