POSITION
5AND LEVEL WASHER
Position washer in final location on clean, dry, firm, and level floor.
NOTE: To avoid damage to legs and base, do not slide washer across floor if leveling legs have been extended.
Loosen 7/8" locknuts and extend front leveling legs. Place rubber foot pads on all four leveling legs. Adjust front 2 leveling legs until machine is level
Once front legs are adjusted, gently tilt washer forward on front legs and lower into place to correctly set rear
Check that washer is level
MUST NOT ROCK.
1. Level Front Legs
| Lock |
| nut |
| Rubber |
Leveling | foot pad |
| |
foot |
|
2. Level rear legs
CONNECT
6POWER CORD TO ELECTRICITY
See Installation Requirements section. Plug washer into
CLEAN TUB AND
7RUN THROUGH ONE WASH CYCLE
WITHOUT CLOTHES
Wipe tub with clean rag and soap diluted in warm water to remove any oil used in manufacturing. Use household spray cleaner if necessary.
Add water and detergent to washtub, and run before first use.
Questions?
See the User’s
Guide or call
Maytag Appliances
Sales Company
USA
Canada
1-800-688-2080 TTY USA Only
3