Installation & Adjustment
Please install and adjust the machine according to the directions contained in this manual. It is very important to follow these directions for the safe operation of the machine, and to ensure your machine operates correctly.
Install the lint filter
After removing washer from outer packaging, take out the lint filter from the document bag, install it to the inner tub. See the figure opposite
Please ensure the lint filter is installed correctly and maintained in good condition to ensure the water outlet is not blocked or the flow altered. If the lint filter is lost or damaged, contact Customer Care.
Model
Inner tub
Lint filter
Model |
Up |
Dismantle |
Install |
Down |
Install the bottom plate
The purpose of the bottom plate is to suppress noise |
|
|
| ||
from the washing machine during operation. |
|
|
|
| |
Steps: |
|
|
|
| |
1. | Lay the washer on its back, on a |
|
|
| Screw |
| surface. | Front |
|
| |
|
|
|
| ||
2. | Place the plate on to the bottom of the machine. |
|
|
| |
3. | Use a screwdriver to tighten the screws ( in |
|
|
|
|
| accessory bag) securing the panel to bottom of | Back | Two fasteners | ||
| the washer. |
|
|
|
|
4. | Once all screws are tight and the panel is |
|
|
|
|
| secure, return the washer to its standing | Cparpet | Bottom plate | ||
| position. |
|
|
|
|
Balance washing machine
Do not install this machine on an incline greater than 2°. Installing machine on an angle or on rough ground will result in unstable running or stoppage of the machine. Please adjust it by the following method:
1.Confirm it is level£»
2.Lift up the side of the leg slightly and twist the adjustable leg.
Note:The distance between the washing machine and wall:at least 20 mm.
20mm | 20mm |
High
Low
4