Installation of water inlet hoses

NOTE: Use the new inlet hoses supplied, do not reuse old hoses.

1. Insert a new flat washer into each end of the inlet hose.

2.Connect the water inlet hose to the water faucet. You may have to use pliers to tighten the coupling. Do not over tighten as this may

cause damage to the valve or hose fittings.

3.Connect the other ends to their respective cold and hot water inlet valves located on the top of the washer.

Nut of the water inlet hose

Water absorption cushion

to Joiner of the water inlet valve

4. Fasten each hose on the washing machine, and ensure a tight connection.

Check the inlet hose connections

1. Swing the hose gently to confirm that the hose is securely fastened.

2. After installation, open the tap to check for leaks.

3. Do not bend the hose unduly.

4. Periodically check the hose connections are firm at both ends. This is to ensure the connections remain watertight over time.

1.Turn off the water taps.

2.Loosen each connection at faucet and washer.

3.Carefully remove each hose separately, as they may contain residual water.