Installation and adjustment

Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.

After you open the package, please lean the washing machine gently down on soft items (like the towel cloth, blanket, ect. ). Install the bottom plate to the bottom of the machine, then lift the machine up gently. See to the figure:

Two claws at the bottom cover shall be inserted in two bar-shaped holes in the stand. Make sure the claws are firmly in place.

Fasten the bottom plate to base frame with one screw

Front

Back

Soft items

Bottom plate

Section I enlarging

The washing machine away from wall should be overrun 20mm. The largest allowable slope of the shank base of the machine is 2°. The slanting or rough ground will result in unstable running or stoppage of the machine. Please adjust it with following methods:

Confirm it's horizontal:

Hang the lead line to check if it is horizontal.

Adjust the adjustable foot:

To twist the adjustable foot, please ﬁ rst lift up the side of the foot slightly, and then you can twist the two adjustable feet. Please make sure to keep the washing machine

in balance.

High Low

The adjustable foot