How to change the direction of the drain hose
1.Dismantle the back cover of the washing machine.
2.Press the spring lamination lightly and pull the top segment of the drain hose decumbent then put down the drain hose from the drain hose frame.
3.Put down the drain hose, squeeze the drain hose lightly and take off the hook, put the drain hose into the cabinet. Take off the small baffle which installed on the other drain outlet and install it on the side which won't install the drain hose.
4.Extend the drain hose from the other side and install it on the base by the drain hose frame
5.Install the back cover.
Back cover
Drain hose frame
Spring lamination |
Remark: In order to make sure of the correct of installation, it is suggested to change the direction of the drain hose with our company serviceman.
The drain hose shall drain smoothly.
1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth, and cost such long time that the machine may stop at mid way.
2.Do not trample or press the drain hose.
3.If the drain hose is too long, cut it at mid point. To make smooth drainage,cut the front end of the hose slantingly.
4.If extra drain hose is needed,please make separate purchase.The inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed 1.5m.
5.If the extra hose is too long,cut it either at A or at B point.
8